Related papers: Threshold Voltage variation with respect to Gate g…
The transition-metal dichalcogenides (TMD) MoS2 and WS2 show remarkable electromechanical properties. Strain modifies the direct band gap into an indirect one, and substantial strain even induces an semiconductor-metal transition. Providing…
Threshold switching (TS) is a phenomenon where non-permanent changes in electrical resistance of a two-terminal device can be controlled by modulating the voltage bias. TS based on silver (Ag) conductive filaments has been observed in many…
The conductance fluctuations of a metallic wire which is interrupted by a small tunnel junction has been explored experimentally. In this system, the bias voltage V, which drops almost completely inside the tunnel barrier, is used to probe…
We predict that the mesoscopic tensile force fluctuations in metal quantum point contacts (nanowires) arise as a result of finite electric voltage on the contact. They are due to reconfiguration of the electronic subsystem and are…
MOSFETs based on wide band-gap semiconductors are suitable for operations at high temperature, at which additional atomic-scale processes that are benign at lower temperatures can get activated which results in device degradation. Recently…
Gate tunable p-type multilayer tin mono-sulfide (SnS) field-effect transistor (FET) devices with SnS thickness between 50 and 100 nm were fabricated and studied to understand their performances. The devices showed anisotropic inplane…
The effect of electrostatic gating on metallic elemental superconductors was recently demonstrated in terms of modulation of the switching current and control of the current phase relation in superconducting quantum interferometers. The…
We show that carbon nanotube transistors exhibit scaling that is qualitatively different than conventional transistors. The performance depends in an unexpected way on both the thickness and the dielectric constant of the gate oxide.…
The performance and scalability of two-dimensional (2D) field-effect transistors (FETs) are strongly influenced by geometry-defined electrostatics. In most 2D FET studies, the gate overlaps with the source and drain electrodes, allowing the…
Improving carrier mobilities of two-dimensional (2D) semiconductors is highly sought after. Recently, Ng. et al. [1] reported rippled molybdenum disulfide (MoS$_2$) transistors on bulged silicon nitride (SiN$_x$) substrates that exhibit…
Anisotropy describes the directional dependence of a material's properties such as transport and optical response. In conventional bulk materials, anisotropy is intrinsically related to the crystal structure, and thus not tunable by the…
In the presence of shot noise the charge on a mesoscopic conductor fluctuates. We are interested in the charge fluctuations which arise if the conductor is in the proximity of a gate to which it is coupled by long range Coulomb forces only.…
Nanostructuring on length scales corresponding to phonon mean free paths provides control over heat flow in semiconductors and makes it possible to engineer their thermal properties. However, the influence of boundaries limits the validity…
In this chapter we intend to discuss the major trends in the evolution of microelectronics and its eventual transition to nanoelectronics. As it is well known, there is a continuous exponential tendency of microelectronics towards…
Tunnel field effect transistors (TFETs) utilizing semiconductor heterojunctions have shown promise for low energy logic but presently do not display subthreshold swings steeper than the room-temperature thermal limit of 60 mV/decade. These…
The latest generation of transistors are nanoscale devices whose performance and reliability are limited by thermal noise in low-power applications. Therefore developing efficient methods to compute the voltage and current fluctuations in…
Frequency stability is key to performance of nanoresonators. This stability is thought to reach a limit with the resonator's ability to resolve thermally-induced vibrations. Although measurements and predictions of resonator stability…
Passing current at given threshold voltages through a metal/insulator/metal sandwich structure device may change its resistive state. Such resistive switching is unique to nanoscale devices, but its underlying physical mechanism remains…
Theoretical treatments of tunneling in electronic devices are often based on one-dimensional (1D) approximations. Here we show that for many nanoscale devices, such as widely studied semiconductor gate-defined quantum dots, 1D…
We investigate the role of electron-phonon scattering and gate bias in degrading the drive current of nanotube MOSFETs. Our central results are: (i) Optical phonon scattering significantly decreases the drive current only when gate voltage…