Related papers: High power fast pulsed magnetron discharges
In this work, amorphous thin films in Mg-Si-O-N system were prepared in order to investigate the dependence of optical and mechanical properties on Mg composition. Reactive RF magnetron co-sputtering from magnesium and silicon targets were…
We present the performance of Multi-gap timing RPCs under irradiation by fully stripped relativistic ions (gamma*beta=2.7, Z=1-6). A time resolution of 80 ps at high efficiency has been obtained by just using standard `off the shelf' 4-gap…
Different thicknesses of cobalt thin films were growth by magnetron sputtering deposition techniques. The films thicknesses were determinated with X ray Photoelectron Spectroscopy (XPS) and Quartz Crystal Monitoring (QCM). XPS is also used…
Time resolved electron density measurements in pulsed RF discharges are shown using a hairpin resonance probe using low cost electronics, on par with normal Langmuir probe boxcar mode operation. Time resolution of less than one microsecond…
Spark plasma sintering (SPS) technique is applied in combination with hydrogen decrepitation process for the recycling of SmCo5 magnets. The SmCo5 magnets for recycling were first decrepitated by hydrogen gas of a pressure of 4 bar for 3…
The work of the miniature magneto-plasma compressor with the low-voltage power supply system was studied experimentally and the current and discharge voltage drop were measured. It was found that the voltage drop (a few tens of volts)…
As a unique perovskite transparent oxide semiconductor, high-mobility La-doped BaSnO3 films have been successfully synthesized by molecular beam epitaxy and pulsed laser deposition. However, it remains a big challenge for magnetron…
Pulsed-laser dry printing of noble-metal microrings with a tunable internal porous structure, which can be revealed via an ion-beam etching post-procedure, was demonstrated. Abundance and average size of the pores inside the microrings were…
There is great need for high intensity proton beams from compact particle accelerators in particle physics, medical isotope production, and materials- and energy-research. To address this need, we present, for the first time, a design for a…
The ability to synthesize high-quality samples over large areas and at low cost is one of the biggest challenges during the developmental stage of any novel material. While chemical vapor deposition (CVD) methods provide a promising…
The presence of magnetohydrodynamic (MHD) acceleration modes in pulsed plasma thrusters has been verified using the magnetic extension of Rankine-Hugoniot theory. However, the impact of initial conditions within the accelerator volume on…
Magnetic refrigeration based on the magnetocaloric effect at room temperature is one of the most attractive alternative to the current gas compression/expansion method routinely employed. Nevertheless, in giant magnetocaloric materials,…
In this work, microwave measurements carried out in dielectric-loaded resonators exposed to high magnetic fields are exploited to yield the surface impedance of Nb$_3$Sn superconducting coatings deposited via two different techniques: vapor…
We present simulations of metallization morphologies under ionized sputter deposition conditions, obtained by a new theoretical approach. By means of molecular dynamics simulations using a carefully designed interaction potential, we…
We propose a quantum simulation of small-polaron physics using a one-dimensional system of trapped ions acted upon by off-resonant standing waves. This system, envisioned as an array of microtraps, in the single-excitation case allows the…
Growth of MgB2 thin films by pulsed laser deposition is examined under ex situ and in situ processing conditions. For the ex situ process, Boron films grown by PLD were annealed at 900 C with excess Mg. For the in situ process, different…
High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature…
We present a pulsed-magnet system that enables x-ray single-crystal diffraction in addition to powder and spectroscopic studies with the magnetic field applied on or close to the scattering plane. The apparatus consists of a single…
Thin films of the charge-ordered (CO) compound Pr$_{0.5}$Ca$_{0.5}$MnO$_{3}$ have been deposited onto (100)-oriented SrTiO$_{3}$ substrates using the Pulsed Laser Deposition technique. Magnetization and transport properties are measured…
We apply particle based kinetic simulations to explore the characteristics of a low-pressure gas discharge driven by high-voltage ( $\sim$ kV) pulses with alternating polarity, with a duty cycle of $\approx$ 1% and a repetition rate of 5…