Related papers: High linear low noise amplifier based on self-bias…
In this work, we propose a novel low complexity Generalised Frequency Division Multiplexing (GFDM) transceiver design. GFDM modulation matrix is factorized into FFT matrices and a diagonal matrix to design low complexity GFDM transmitter.…
Based on a new equivalent model of quantizer with noisy input recently presented in [23], we propose a new low complexity receiver that takes into account the nonlinear distortion (NLD) generated by Analog to Digital converter (ADC) with…
High power and low phase noise oscillators at terahertz frequencies are required for several burgeoning scientific and technological applications, including radioastronomy, imaging, molecular spectroscopy, radar, and wireless…
Low-noise amplifiers are of great importance in the field of quantum technologies. We study a thermally driven parametric amplifier based on a superconductor-insulator-graphene-insulator-superconductor (SIGIS) junction coupled to a…
Power limiters are essential devices in modern radio frequency (RF) communications systems to protect highly sensitive input channels from large incoming signals. Nowadays-used semiconductor limiters suffer from high electronic noise and…
A well-balanced detector with high sensitivity and low noise is presented in this paper. The two-stage amplification structure is used to increase electronic gain while keeping an effective bandwidth of about 70 MHz. In order to further…
Light source is indispensable component in on-chip system. Compared with hybrid or heterogeneous integrated laser, monolithically integrated laser is more suitable for high density photonic integrated circuit (PIC) since the capability of…
In this paper, we present an on-chip antenna at 290 GHz that achieves a maximum efficiency of 42\% on a low-resistivity silicon substrate for sub-terahertz integrated transceivers. The proposed antenna is based on a dual-slot structure to…
This paper addresses the standard generalized likelihood ratio test (GLRT) detection problem of weak signals in background noise. In so doing, we consider a nonfluctuating target embedded in complex white Gaussian noise (CWGN), in which the…
Bottom-up synthesized GNRs and GNR heterostructures have promising electronic properties for high performance field effect transistors (FETs) and ultra-low power devices such as tunnelling FETs. However, the short length and wide band gap…
This contribution presents the design, production, and initial testing of newly developed 4H-SiC Low Gain Avalanche Detectors (LGADs). The evaluation includes performance metrics such as the internal gain layer's efficiency in enhancing…
We report on the noise of a lumped element Direct Current Superconducting Quantum Interference Device amplifier. We show that the noise temperature in the 4 GHz-8 GHz range over ranges of 10's of MHz is below 1 kelvin (three photons of…
Magnonics is a rapidly growing field, attracting much attention for its potential applications in data transport and processing. Many individual magnonic devices have been proposed and realized in laboratories. However, an integrated…
The Quad transimpedance and limiting amplifier (QTIA) is a 4-channel array optical receiver ASIC, developed using a 65 nm CMOS process. It is configurable between the bit rate of 2.56 Gbps and 10 Gbps per channel. QTIA offers careful…
With the extreme scaling, active devices in both CMOS and BiCMOS technologies have reached outstanding ft/fmax, enabling an ever-increasing number of existing and emerging applications in the microwave and millimeter wave (mm-wave)…
In future full-duplex communications, the cancellation of self-interference (SI) arising from hardware non-idealities will play an important role in the design of mobile-scale devices. To this end, we introduce an optimal digital SI…
Massive multiple-input multiple-output (MIMO) is a key technology for 5G wireless communications with a promise of significant capacity increase. The use of low-resolution data converters is crucial for massive MIMO to make the overall…
Precision instrumentation systems, such as optical receivers and other current-output measurement systems, often contain a transimpedance amplifier (TIA). The commonly used resistive feedback TIA (RF-TIA) has a drawback in its practical…
We describe a microwave amplifier based on the Superconducting Low-inductance Undulatory Galvanometer (SLUG). The SLUG is embedded in a microstrip resonator, and the signal current is injected directly into the device loop. Measurements at…
Transformer-based speech enhancement models yield impressive results. However, their heterogeneous and complex structure restricts model compression potential, resulting in greater complexity and reduced hardware efficiency. Additionally,…