Related papers: High linear low noise amplifier based on self-bias…
Based on the principles of microwave circuit interferometry we have constructed a Reduced Noise Amplifier (RNA) with power spectral density of phase, as well as amplitude, fluctuations close to -170 dBc/Hz at 1 kHz offset. The RNA has been…
We report on the realization of a high sensitivity RF noise measurement scheme to study small current fluctuations of mesoscopic systems at milliKelvin temperatures. The setup relies on the combination of an interferometric ampli- fication…
The present article primarily focuses on the design of an ultra-low-noise amplifier specifically tailored for quantum applications. The circuit design places a significant emphasis on improving the noise figure, as quantum-associated…
We describe a novel scheme for low-noise phase-insensitive linear amplification at microwave frequencies based on the Superconducting Low-inductance Undulatory Galvanometer (SLUG). Direct integration of the junction equations of motion…
In this paper a new design of MMIC based LNA is outlined. This design uses a discrete 100-nm InP HEMT placed in front of an existing InP MMIC LNA to lower the overall noise temperature of the LNA. This new approach known as the Transistor…
In this paper, we propose a low-complexity blind estimator for the average noise power, average signal power, and signal-to-noise ratio (SNR) in millimeter-wave (mmWave) massive multi-antenna uplink systems. In particular, the proposed…
The growing number of phased array feeds (PAF) being built for radio astronomy demonstrates an increasing need for low noise amplifiers (LNA) that are designed for repeatability, low noise, and ease of manufacture. Specific design features…
In this paper, we report a new scheme to amplify a microwave signal carried on a laser light at $\lambda$=852nm. The amplification is done via a semiconductor tapered amplifier and this scheme is used to drive stimulated Raman transitions…
We demonstrate a low noise, high-gain, resonant optical amplifier that combines injection locking with feed-forward cancellation of residual phase noise. The wavelength-agnostic architecture uses a commercial semiconductor diode laser as a…
A transimpedance amplifier has been designed for scanning tunneling microscopy (STM). The amplifier features low noise (limited by the Johnson noise of the 1 G{\Omega} feedback resistor at low input current and low frequencies), sufficient…
Radio telescope front ends must have simultaneously low noise and sufficiently-high linearity to accommodate interfering signals. Typically these are opposing design goals. For modern radio telescopes operating in the HF (3-30 MHz) and…
The paper describes the project, implementation and test of a C-band (5GHz) Low Noise Amplifier (LNA) using new low noise Pseudomorphic High Electron Mobility Transistors (pHEMTS) from Avago. The amplifier was developed to be used as a cost…
Low-noise lasers are of central importance in a wide variety of applications, including high spectral-efficiency coherent communication protocols, distributed fibre sensing, and long distance coherent LiDAR. In addition to low phase noise,…
Throughput optimization of optical communication systems is a key challenge for current optical networks. The use of gain-flattening filters (GFFs) simplifies the problem at the cost of insertion loss, higher power consumption and…
Guiding and manipulating GHz frequency acoustic waves in $\mu$m-scale waveguides and resonators opens up new degrees of freedom to manipulate radio frequency (RF) signals in chip-scale platforms. A critical requirement for enabling…
In ambient backscatter communication (AmBC), strong direct interference from the ambient source poses a major challenge to reliable symbol detection. Although previous studies have shown that employing a low-noise amplifier (LNA) in…
Ultra-low frequency noise lasers have been widely used in laser-based experiments. Most narrow-linewidth lasers are implemented by actively suppressing their frequency noise through a frequency noise servo loop (FNSL). The loop bandwidths…
In this paper we describe the status of the first prototype of the 60 GHz wireless Multi-gigabit data transfer topology currently under development at University of Heidelberg using IBM 130 nm SiGe HBT BiCMOS technology. The 60 GHz band is…
A 20 GHz LLRF system is being built using a two-board(RF Front End + ADC/DAC/FPGA) architecture. The RF Front End provides 8 down-converting channels and 3 up-converting channels (5.5-20 GHz RF to 0.05-3 GHz IF). Separate, phase locked,…
The next-generation sensing and communication applications rely on high-frequency microwave generation with low-noise. The microwave photonic technology is promising by the practical application is limited by its complex architecture so…