Related papers: Multiphase strontium molybdate thin films for plas…
Electric and thermoelectric properties of strictly monolayer MoS$_2$ films, which are grown using a novel micro-cavity based CVD growth technique, have been studied under diverse environmental and annealing conditions. Resistance of a…
Vanadium oxide films and fibers have been fabricated by the acetylacetonate sol-gel method followed by annealing in wet nitrogen. The samples are characterized by X-ray diffraction and electrical conductivity measurements. The effects of a…
Control of thin film stoichiometry is of primary relevance to achieve desired functionality. Pulsed laser deposition ablating from binary-oxide targets (sequential deposition) can be applied to precisely control the film composition,…
We investigate the low temperature properties of two-dimensional Lennard-Jones glass films, prepared in silico both by liquid cooling and by physical vapor deposition. We identify deep in the solid phase a crossover temperature $T^*$, at…
Thin Ba0.5Sr0.5TiO3 (BST) films on p-type Si (100) using The Chemical Solution Deposition (CSD) method. X-ray diffraction (XRD), Scanning electron microscopy (SEM), C-V meter analysis measurement were employed to characterise the films. The…
The ability to synthesis well-ordered two-dimensional materials under ultra-high vacuum and directly characterize them by other techniques in-situ can greatly advance our current understanding on their physical and chemical properties. In…
Superconducting thin films have been prepared on Si-substrates, using pulsed laser deposition from a target composed of a mixture of Mg and MgB2 powders. The films were deposited at room temperature and post-annealed at 600 degrees C. The…
For a detailed study on the semiconductor to metal transition (SMT) in ZnO thin films doped with Al in the concentration range from 0.02 to 2%, we grew these films on (0001) sapphire substrates using sequential pulsed laser deposition. It…
In recent years, excitation of surface phonon polaritons (SPhPs) in van der Waals materials received wide attention from the nanophotonics community. Alpha-phase Molybdenum trioxide ($\alpha$-MoO3), a naturally occurring biaxial hyperbolic…
Vanadium silicide (V$_3$Si) is a promising superconductor for integration with silicon-based electronics, however the interfacial growth kinetics have a strong influence on the resulting superconducting properties and are not yet fully…
Using isothermal and temperature-dependent electrical measurements, we investigated the resistive switching mechanism of amorphous titanium oxide thin films deposited by a plasma-enhanced atomic layer deposition method between two aluminum…
We report the growth of high-quality epitaxial MgB2 thin films on (1102) Al2O3 and (001) SrTiO3 substrates by using a pulsed laser deposition technique. The thin films grown on Al2O3 substrates show a Tc of 39 K with a sharp transition…
The two-dimensional layer of molybdenum disulfide (MoS2) has recently attracted much interest due to its direct-gap property and potential applications in optoelectronics and energy harvesting. However, the synthetic approach to obtain high…
The fabrication of optically smooth thin Sn films by vacuum or electrodeposition techniques is usually challenging. Little has been published on how to address this challenge mainly because very few applications require such smooth Sn…
Antimony sulfide (Sb$_2$S$_3$), a compound of earth-abundant elements with highly anisotropic, quasi-layered crystal structure, triggered growing interest as a solar absorber in photovoltaics and as a phase change material in memory…
Thin aluminum oxide films were deposited by a new and simple physicochemical method called chemical liquid phase deposition (CLD) on semiconductor materials. Aluminum sulfate with crystallized water and sodium bicarbonate were used as…
This article identifies the process of crystallization of thin high-$\kappa$ dielectric films and an optimal range of annealing temperature in the field of high-$\kappa$ dielectric-based metal-oxide-semiconductor (MOS) technology for its…
We report a Raman scattering investigation of KTa1-xNbxO3 (x = 0.35, 0.5) thin films deposited on MgO and LaAlO3 as a function of temperature. The observed phase sequence in the range from 90 K to 720 K is similar to the structural phase…
This paper reports a suspended thin-film lithium niobate (LN) piezoelectric resonator platform surviving high annealing temperatures of 550 {\deg}C, among the highest temperature at which the thermal resilience of suspended LN resonators is…
SrTiO$_{3}$ is one of the most popular insulating single-crystal substrates for various complex-oxide thin film growths, because of its good lattice match with many complex oxide films. Here, we show that a common thin film processing…