Related papers: Si Nanowire - Array Source Gated Transistors

We demonstrate the formation of semimetal graphite/semiconductor Schottky barriers where the semiconductor is either silicon (Si), gallium arsenide (GaAs) or 4H-silicon carbide (4H-SiC). Near room temperature, the forward-bias diode…

A novel bipolar transistor structure, namely, a SiC emitter lateral NPM Schottky collector bipolar transistor (SCBT) with a silicon-on-insulator (SOI) substrate is explored using two-dimensional (2-D) simulation. A comprehensive comparison…

In this paper, we have worked out a pseudo two dimensional (2D) analytical model for surface potential and drain current of a long channel p-type Dual Material Gate (DMG) Gate All-Around (GAA) nanowire Tunneling Field Effect Transistor…

Ability to understand and model the performance limits of nanowire transistors is the key to design of next generation devices. Here, we report studies on high-mobility junction-less gate-all-around nanowire field effect transistor with…

Ferroelectric field-effect transistors employ a ferroelectric material as a gate insulator, the polarization state of which can be detected using the channel conductance of the device. As a result, the devices are of potential to use in…

We develop an InAs nanowire gate-all-around field-effect transistor using a transparent conductive zinc oxide (ZnO) gate electrode, which is in-situ atomic layer deposited after growth of gate insulator of Al2O3. We perform…

A low complexity computational model of the current-voltage characteristics for graphene nano-ribbon (GNR) field effect transistors (FET), able to simulate a hundred of points in few seconds using a PC, is presented. For quantum capacitance…

This paper reports on the physical and temperature-dependent electrical characterizations of the oxide/semiconductor interface in MOS capacitors with a SiO2 layer deposited on 4H-SiC using dichlorosilane and nitrogen-based vapor precursors.…

We propose and analyze a novel dual-gate Spin Field Effect Transistor (SpinFET) with half-metallic ferromagnetic source and drain contacts. The transistor has two gate pads that can be biased independently. It can be switched ON or OFF with…

At a superconductor (S)-normal metal (N) junction pairing correlations can "leak-out" into the N region. This proximity effect [1, 2] modifies the system transport properties and can lead to supercurrent flow in SNS junctions [3]. Recent…

Field-effect transistors (FETs) with single gates are adversely affected by short channel effects such as drain-induced barrier lowering (DIBL) and increases in the magnitude of sub-threshold swing as the channel length is reduced.…

The development of a materials platform that exhibits both superconducting and semiconducting properties is an important endeavour for a range of emerging quantum technologies. We investigate the formation of superconductivity in nanowires…

A simple and highly reproducible single electron transistor (SET) has been fabricated using gated silicon nanowires. The structure is a metal-oxide-semiconductor field-effect transistor made on silicon-on-insulator thin films. The channel…

Single electron transistors (SETs) are fabricated by placing single walled carbon nanotubes (SWNTs) on a 100 nm wide local Al/Al2O3 bottom gate and then contacting with Pd electrodes. Coulomb oscillations up to 125 K were observed and…

Fast cryogenic switches with ultra-low power dissipation are highly sought-after for control electronics of quantum computers, space applications and next generation logic circuits. However, existing high-frequency switches are often bulky,…

Black phosphorous (BP) is is recently unveiled as a promising two-dimensional direct bandgap semiconducting material. Here, we report the ambipolar field effect transistor behavior of multilayers of BP with ferromagnetic tunnel contacts. We…

The electrical contact to two-dimensional (2D)-semiconductor materials are decisive to the electronic performance of 2D-semiconductor field-effect devices (FEDs). The presence of a Schottky barrier often leads to a large contact resistance,…

The potential barrier height at the interface formed by a metal contact and multiple one-dimensional (1D) quasi-ballistic channels in field-effect transistors (FETs) is evaluated across different carbon nanotube and nanowire device…

Here we demonstrate that water-infiltrated nanoporous glass electrically switches an oxide semiconductor from an insulator to metal. We fabricated the field effect transistor structure on an oxide semiconductor, SrTiO3, using…

Graphene field-effect transistors are integrated with solution-processed multilayer hybrid organic-inorganic self-assembled nanodielectrics (SANDs). The resulting devices exhibit low-operating voltage (2 V), negligible hysteresis, current…