Related papers: Computer simulation of a-Si/c-Si heterojunction so…
The P+ {\alpha}-Si /N+ polycrystalline solar cell is molded using the AMPS-1D device simulator to explore the new high efficiency thin film poly-silicon solar cell. In order to analyze the characteristics of this device and the thickness of…
In this paper we carried out theoretical study of the general issues related to the efficiency of SiC:H/a-Si:H single- and multi-junction tandem solar cells. Implementation of numerical simulations by the use of AMPS-1D program of…
In order to obtain higher conversion efficiency and to reduce production cost for amorphous silicon/crystalline silicon (a-Si/c-Si) based heterojunction solar cells, a Heterojunction of Amorphous silicon and Crystalline silicon with…
The influences of work function of transparent conducting oxides (TCO) on the per-formance of organic solar cells, including open circuit voltage, conversion efficiency and fill factor, has been simulated. It is obtained that for non-Ohmic…
Solar modules are currently characterized at standard test conditions (STC), defined at 1000W/m2 and 25 {\deg}C. However, solar modules in actual outdoor operating conditions typically operate at lower illumination and higher temperature…
The selfconsistent model for the temperature dependence of photoconversion efficiency $\eta$ for highly efficient silicon solar cells (SCs) is developed. It is demonstrated that effect of the efficiency decrease due to increasing…
The photovoltaic properties of carbon nanotube/Si heterojunction solar cells were investigated using network films of high quality single-walled carbon nanotubes (SWNTs) grown by atmospheric-pressure floating-catalyst chemical vapor…
Practical device architectures are proposed here for the implementation of three-terminal heterojunction bipolar transistor solar cells (3T-HBTSCs). These photovoltaic devices, which have a potential efficiency similar to that of…
In this article, we demonstrate the design and simulation of a highly-efficient n-CdS/p-CIGS/p+-CGS dual heterojunction solar cell. The simulation was performed using SCAPS-1D software with reported experimental physical parameters. The…
This study explores the impact of an optimized amorphous silicon (a-Si) buffer layer on AlxIn1-xN-on-Si(100) heterojunction solar cells, with Al content varying from 0% (InN) to 55%. The buffer layer improves the structural quality of the…
The theoretical analysis of photovoltaic conversion efficiency of highly effective silicon solar cells (SC) is performed for n-type and p-type bases. The case is considered when the Shockley-Read-Hall recombination in the silicon bulk is…
We show that the highly conductive polymer poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT:PSS) can successfully be applied as a hole selective front contact in silicon heterojunction (SHJ) solar cells. In combination with a…
We propose a new triple-junction solar cell structure composed of a III-V heterojunction bipolar transistor solar cell (HBTSC) stacked on top of, and series-connected to, a Si solar cell (III-V-HBTSC-on-Si). The HBTSC is a novel…
We present a model for simulating performance of 3D nano -coaxial and -hemispherical thin film solar cells. The material system considered in these simulations is hydrogenated amorphous silicon (a-Si:H), with solar cells fabricated in an…
Since the photoconversion efficiency $\eta$ of the silicon-based solar cells (SCs) under laboratory conditions is approaching the theoretical fundamental limit, further improvement of their performance requires theoretical modeling and/or…
Nano-scaled metallic or dielectric structures may provide various ways to trap light into thin-film solar cells for improving the conversion efficiency. In most schemes, the textured active layers are involved into light trapping structures…
Silicon solar cells dominate the solar cell market with record lab efficiencies reaching almost 26%. However, after 60 years of research, this efficiency saturated close to the theoretical limit for silicon, and radically new approaches are…
Organic heterojunction solar cells are analyzed within a minimal model that includes the essential physical features of such systems. The dynamical properties of this model, calculated using a master equation approach, account for the…
In spite of having higher carrier mobilities and absorption coefficients of germanium (Ge) than those of silicon (Si), there has been less focus on Ge-based solar cells due to the low bandgap and high-cost of Ge wafer as well as requirement…
We simulated photovoltaic characteristics of single heterojunction solar cell with Cu2ZnSnS4 and Cu2ZnSnSe4 absorber layer numerically using one dimensional solar cell capacitance simulator (SCAPS-1D). n-CdS/ZnO double buffer layer is used…