Related papers: Computer simulation of a-Si/c-Si heterojunction so…
We theoretically study the efficiency limits and performance characteristics of few-layer graphene-semiconductor solar cells (FGSCs) based on a Schottky contact device structure. We model and compare the energy conversion efficiency of…
A systematic survey and subsequent research have been made on MoTe2-based n-CdS/p-MoTe2/p+-CGS device in solar cell and photodetector field. The optimization has been established by altering the various properties of each constituent layer…
Light management is of great importance to photovoltaic cells, as it determines the fraction of incident light entering the device. An optimal pn-junction combined with an optimal light absorption can lead to a solar cell efficiency above…
We report on very high enhancement of thin layer's absorption through band-engineering of a photonic crystal structure. We realized amorphous silicon (aSi) photonic crystals, where slow light modes improve absorption efficiency. We show…
High density and uniformity sub-100nm surface oxidized silicon nanocone forest structure is created and integrated onto the existing texturization microstructures on photovoltaic device surface by a one-step high throughput plasma enhanced…
Luminescence solar concentrators act as semi-transparent photovoltaic cells and can be applied to large surface areas in modern urban environment. In this paper their optical efficiencies were analytically derived for different unit shapes…
The characteristics of a hydrogenated amorphous silicon (a-Si:H) detector are presented here for monitoring in space solar flares and the evolution of large energetic proton events up to hundreds of MeV. The a-Si:H presents an excellent…
In this article, we continue our mathematical study of organic solar cells (OSCs) and propose a two-scale (micro- and macro-scale) model of heterojunction OSCs with interface geometries characterized by an arbitrarily complex morphology.…
Singlet fission, an exciton multiplication process in organic semiconductors which converts one singlet exciton into two triplet excitons is a promising way to reduce thermalization losses in conventional solar cells. One way to harvest…
Thermophotovoltaic systems in principle enable utilization of heat that is usually regarded as wasted energy. However, the wavelength selectivity of the thermal emitter required for high efficiencies is rather difficult to control with…
The charge carrier mobility is a key parameter for the organic bulk heterojunction solar cell efficiency. It was recently shown that the interplay charge carrier transport and recombination, both depending on electron and hole mobilities,…
Solar redox flow batteries (SRFB) have received much attention as an alternative integrated technology for simultaneous conversion and storage of solar energy. Yet, the photocatalytic efficiency of semiconductor-based single photoelectrode,…
Solar energy is clean and renewable but has a low flux density. The lack of a continuous and reliable power supply reduces their average daily output. Since the infrared part is not utilized to produce electricity, conventional photovoltaic…
Si doped ZnO has been reported to be a better conductor than pure ZnO. It is reported that carrier density increases and hence conductivity increases. However, the effect on optical transmission is yet not clear until our recent report [1].…
Conventional photovoltaic machinery, including traditional silicone panels, fails to address efficiency problems. Recent technological advances suggest less metal-specific reliance, but plastic substrates are bound by cost-inefficiency.…
The hot carrier solar cell (HCSC) has the potential for converting solar energy into electrochemical energy with an efficiency of 85.4%. For this, in addition to an idealized light absorber, the HCSC has to be connected to the external load…
The paper presents a quantitative approach to the investigation and comparison of the material qualities of III-V on silicon (III-V/Si) solar cells by using external radiative efficiencies. We use this analysis to predict the limiting…
Computational searching and screening of new functional materials exploiting earth abundant elements can accelerate developments of their energy applications. Based on a state-of-the-art materials search algorithm and ab initio…
The performance of a combined solar photovoltaic (PV) and thermoelectric generator (TEG) system is examined using an analytical model for four different types of commercial PVs and a commercial bismuth telluride TEG. The TEG is applied…
Solar cells based on conventional semiconductors have low efficiency in converting solar energy into electricity because the excess energy beyond the gap of an incident solar photon is converted into heat by phonons. Here we show by ab…