Related papers: A waveguide-coupled thermally-isolated radiometric…
An inverse problem for a stationary heat transfer process is studied for a totally isolated bar on its lateral surface, made up of two consecutive sections of different, isotropic and homogeneous materials, perfectly assembly, where one of…
Carbon nanotubes (CNTs) are quasi-1D nanostructures that display both high thermal conductivity and intriguing low-dimensional phonon transport phenomena. In comparison to the advances made in the theoretical calculation of the lattice…
We have designed, fabricated and characterized absorptive thermal blocking filters for cryogenic microwave applications. The transmission line filter's input characteristic impedance is designed to match $50\,\Omega$ and its response has…
Toward measuring the thermal properties of exfoliated atomically thin materials, we demonstrate simultaneous measurements of the thermal conductivity and specific heat in suspended membranes. We use the 3{\omega} technique applied to…
A vacuum compatible cryogenic accelerometer is presented which will reach $<0.5$ p$g$ Hz$^{-1/2}$ sensitivity from 1 mHz to 10 Hz with a maximum sensitivity of 10 f$g$ Hz$^{-1/2}$ around 10 Hz. This figure can be translated to a…
Dual-polarization heterodyne receivers operating at 325 GHz, 424 GHz, and 650 GHz at room temperature are presented. Polarimetric measurements are enabled by two orthogonal open-ended E-field probes, co-optimized and integrated with two…
The ability to transport energy is a fundamental property of the two-dimensional Dirac fermions in graphene. Electronic thermal transport in this system is relatively unexplored and is expected to show unique fundamental properties and to…
We present a scheme and demonstrate measurements of a Coulomb blockade thermometer (CBT) in a microwave transmission setup. The sensor is embedded in an $LCR$ resonator, where $R$ is determined by the conductance of the junction array of…
X-ray calorimetric sample platforms combining specific heat and synchrotron x-ray measurements provide a powerful means to investigate fundamental material properties. Calorimeter cell designs featuring a compact heater and thermometer…
We show that in mesoscopic four-terminal thermoelectric devices with two electrodes (the source and the drain) and two heat baths, inelastic scattering processes can lead to unconventional thermoelectric transport. The source (or the drain)…
Colloidal quantum dots (QDs) and their thin-films are increasingly used in electronic and photonic devices replacing traditional bulk semiconductors. However, thermal properties of the QDs are comparatively underexplored relative to device…
This paper reports the characterization of hollow metallic waveguides (HMW) to be used as single-mode wavefront filters for nulling interferometry in the 6-20 microns range. The measurements presented here were performed using both…
We report a proof-of-principle experiment for a new method of temperature measurements in waveguide quantum electrodynamics (wQED) experiments, allowing one to differentiate between global and local baths. The method takes advantage of…
We present proof-of-operation for a new method of electron thermometry using microwave impedance of a hafnium micro-absorber. The new method leads to an ultimate THz-range detector suitable for microwave readout and frequency division…
We report on the scattering parameters and Johnson noise emission of low-pass stripline filters employing a magnetically loaded silicone dielectric down to 25 mK. The transmission characteristic of a device with $f_{-3dB}$=1.3 GHz remains…
We report on an optimized micro-machined thermal flow-rate sensor as part of an autonomous multi-parameter sensing device for water network monitoring. The sensor has been optimized under the following constraints: low power consumption and…
We present 21-cm absorption measurements towards 12 radio continuum sources with previously identified thermally-unstable warm neutral medium (WNM). These observations were obtained with the Expanded Very Large Array (EVLA) and were…
Thermal Kinetic Inductance Detectors (TKIDs) combine the excellent noise performance of traditional bolometers with a radio frequency multiplexing architecture that enables the large detector counts needed for the next generation of…
A cryogenic quantum dot thermometer is calibrated and operated using only a single non-galvanic gate connection. The thermometer is probed with radio-frequency reflectometry and calibrated by fitting a physical model to the phase of the…
This work presents a self-heating study of a 40-nm bulk-CMOS technology in the ambient temperature range from 300 K down to 4.2 K. A custom test chip was designed and fabricated for measuring both the temperature rise in the MOSFET channel…