Related papers: A New Design for Array Multiplier with Trade off i…
A large amount of research is currently going on in the field of reversible logic, which have low heat dissipation, low power consumption, which is the main factor to apply reversible in digital VLSI circuit design. This paper introduces…
This paper proposes a novel multilevel inverter for automotive applications. The topology consists of a modular DCDC converter and a tap selector, where the DC-DC converter provides several DC-output levels and the tap selector produces an…
High peak-to-average power ratio (PAPR) has long posed a challenge for multi-carrier systems, impacting amplifier efficiency and overall system performance. This paper introduces dynamic angle fractional Fourier division multiplexing…
This paper proposes a joint transmitter-receiver design to minimize the weighted sum power under the post-processing signal-to-interference-and-noise ratio (post-SINR) constraints for all subchannels. Simulation results demonstrate that the…
The time division multiple access (TDMA) technique has been applied in automotive multiple-input multiple-output (MIMO) radar. However, it suffers from the transmit energy loss, and as a result the parameter estimation performance…
Large-scale artificial neural networks have shown significant promise in addressing a wide range of classification and recognition applications. However, their large computational requirements stretch the capabilities of computing…
Semiconductor optical amplifiers (SOA) are a fundamental building block for many photonic systems. However, their power inefficiency has been setting back operational cost reduction, and the resulting thermal losses constrain…
In-memory computing is a promising alternative to traditional computer designs, as it helps overcome performance limits caused by the separation of memory and processing units. However, many current approaches struggle with unreliable…
A complex digital circuit comprises of adder as a basic unit. The performance of the circuit depends on the design of this basic adder unit. The speed of operation of a circuit is one of the important performance criteria of many digital…
We introduce a framework for linear precoder design over a massive multiple-input multiple-output downlink system in the presence of nonlinear power amplifiers (PAs). By studying the spatial characteristics of the distortion, we demonstrate…
This paper describes a low-power processor tailored for fast Fourier transform computations where transport triggering template is exploited. The processor is software-programmable while retaining an energy-efficiency comparable to existing…
An Artificial Magnetic Conductor (AMC) frame capable of improving the impedance matching of a 2$\times$2 array for 6G applications without degrading isolation performance is presented. The proposed frame is integrated into the array without…
In this paper, we aim to design highly energy efficient end-to-end communication for millimeter wave multiple-input multiple-output systems. This is done by jointly optimizing the digital-to-analog converter (DAC)/analog-to-digital…
The Coupled Cavity Drift Tube Linac (CCDTL) used in the Accelerator for the Production of Tritium (APT) is fully described elsewhere [1]. The modules are composed of several machined and brazed segments that must account for the…
Computation-in-Memory (CiM) is attracting attention as a technology that can perform MAC calculations required for AI accelerators, at high speed with low power consumption. However, there is a problem regarding power consumption and…
This paper presents the analysis of an efficient alternative interface circuit for MEMS electrostatic energy harvesters. It is entirely composed by diodes and capacitors. Based on modeling and simulation, the anti-phase gap-closing…
The many cores design research community have shown high interest in optical crossbars on chip for more than a decade. Key properties of optical crossbars, namely a) contention-free data routing b) low-latency communication and c) potential…
Transformers provide a class of expressive architectures that are extremely effective for sequence modeling. However, the key limitation of transformers is their quadratic memory and time complexity $\mathcal{O}(L^2)$ with respect to the…
Dynamic comparators are an essential part of low-power analog to digital converters (ADCs) and are referred to as one of the most important building blocks in mixed mode circuits. The power consumption and accuracy of dynamic comparators…
Sub-terahertz (sub-THz) antenna array architectures significantly impact power usage and communications capacity in multi-user multiple-input multiple-output (MU-MIMO) systems. In this work, we compare the energy efficiency and spectral…