Related papers: ATLAS Experiment Pixel Detector Upgrades
The ALICE Collaboration is developing a novel vertexing detector to extend the heavy-flavour physics programme of the experiment during Run 4 by improving the pointing resolution of the tracking, particularly at low transverse momentum. It…
The innermost part of the ATLAS experiment will be a pixel detector containing around 1750 individual detector modules. A detector control system (DCS) is required to handle thousands of I/O channels with varying characteristics. The main…
The R&D activity presented is focused on the development of new modules for the upgrade of the ATLAS pixel system at the High Luminosity LHC (HL-LHC). The performance after irradiation of n-in-p pixel sensors of different active thicknesses…
The ALICE experiment at CERN has undergone a major upgrade during the Long Shutdown 2 of the LHC during 2019-2021. A key element is the installation of the new Inner Tracking System 2 (ITS2). The new ITS2 based on CMOS Monolithic Active…
BDAQ53 is a readout system and verification framework for hybrid pixel detector readout chips of the RD53 family. These chips are designed for the upgrade of the inner tracking detectors of the ATLAS and CMS experiments. BDAQ53 is used in…
The ALICE ITS3 (Inner Tracking System 3) upgrade project and the CERN EP R&D on monolithic pixel sensors are investigating the feasibility of the Tower Partners Semiconductor Co. 65 nm process for use in the next generation of vertex…
The average minimum number of bits needed for lossless readout of a pixel detector is calculated, in the regime of interest for particle physics where only a small fraction of pixels have a non-zero value per frame. This permits a…
We report on the 3-year INFN ATLAS-CMS joint research activity in collaboration with FBK, started in 2014, and aimed at the development of new thin pixel detectors for the High Luminosity LHC Phase-2 upgrades. The program is concerned with…
We have developed a silicon pixel detector to enhance the physics capabilities of the PHENIX experiment. This detector, consisting of two layers of sensors, will be installed around the beam pipe at the collision point and covers a…
A large Time Projection Chamber is the main device for tracking and charged-particle identification in the ALICE experiment at the CERN LHC. After the second long shutdown in 2019/20, the LHC will deliver Pb beams colliding at an…
The LHC Phase-II upgrade will lead to a significant increase in luminosity, which in turn will bring new challenges for the operation of inner tracking detectors. A possible solution is to use active silicon sensors, taking advantage of…
The upgraded Inner Tracking System (ITS2) of the ALICE experiment at the CERN Large Hadron Collider is based on Monolithic Active Pixel Sensors (MAPS). With a sensitive area of about 10 $m^2$ and 12.5 billion pixels, ITS2 represents the…
Silicon pixel detectors produced according to the ATLAS Pixel Detector design were tested in a beam at CERN in the framework of the ATLAS collaboration. The detectors used n+/n sensors with oxygenated silicon substrates. The experimental…
The upgrade of the Inner Tracking System (ITS) of ALICE (A Large Ion Collider Experiment) will extend measurements of heavy-flavour hadrons and low-mass dileptons to a lower transverse momentum than currently achieved and increase the…
The Tile Calorimeter (TileCal) is the hadronic calorimeter covering the most central region of the ATLAS experiment at LHC. The TileCal readout consists of about 10000 channels. The ATLAS upgrade program is divided in three phases: The…
The LHCb experiment is set for a significant upgrade, which will be ready for Run 3 of the LHC in 2020. This upgrade will allow LHCb to run at a significantly higher instantaneous luminosity and collect an integrated luminosity of…
The CMS Phase-1 pixel detector was extracted from the underground cavern after the end of the LHC Run-2 in 2019 and has been kept cold to protect the silicon sensors during the long shutdown period (LS2) in 2019-2021. The LHC is now…
The use of CMOS Pixel Sensors (CPS) for high resolution and low material vertex detectors has been validated with the 2014 and 2015 physics runs of the STAR-PXL detector at RHIC/BNL. This opens the door to the use of CPS for inner tracking…
The ATLAS Forward Physics (AFP) project plans to install 3D silicon pixel detectors about 210 m away from the interaction point and very close to the beamline (2-3 mm). This implies the need of slim edges of about 100-200 $\mu$m width for…
For the ATLAS Pixel Detector fast readout electronics has been successfully developed and tested. Main attention was given to the ability to detect small charges in the order of 5,000 electrons within 25 ns in the harsh radiation…