Related papers: Preparation of Cobalt Thin Films by Sputtering Sys…

Epitaxial copper thin films were deposited by magnetron sputtering. The adatoms during deposition are influenced by deposition parameters which cause variations in thin film properties. XRD and FESEM studies were done to get an insight into…

We have deposited Co films on the GaAs(001) surface by using an e-beam evaporation method. The thicknesses of the Co films are measured by using x-ray reflectivity and Rutherford backscattering. The magnetic properties of the films have…

Compositionally graded Fe-Pt thin films were prepared on stationary 100 mm Si substrates by magnetron sputtering a base target of Fe on which a piece of Pt is asymmetrically positioned. Energy Dispersive X-Ray analysis was used to map the…

Amorphous sputtered Co-based thin films are widely used as soft magnetic materials in applications such as sensors, inductors and magnetic flux concentrators. The magnetic properties of these films can be controlled by deposition parameters…

We present room temperature ferromagnetic resonance (FMR) studies of polycrystalline ||Pt/10 nm Cu/t Co/10 nm Cu/Pt|| films as a function of Co layer thickness (1 < t < 10 nm) grown by evaporation and magnetron sputtering. FMR was studied…

Copper deposition has been carried out at various time span on glass slide and silicon substrate by using indigenously developed unbalanced type DC magnetron sputtering system. The main objective of this work is to study the crystalline…

Sculptured copper thin films were deposited on glass substrates, using different deposition rates. The nano-structure and morphology of the films were obtained, using X-ray diffraction (XRD), atomic force microscopy (AFM) and scanning…

Nanocrystalline FeCuNbSiB thin films were fabricated through magnetron sputtering followed by heat treatment, resulting in samples characterized by low coercivity and high effective magnetization. Comprehensive microstructural analysis,…

Thin films of the recently discovered magnesium diboride (MgB2) intermetalic superconducting compound have been grown using a magnetron sputtering deposition technique followed by in-situ annealing at 830 C. High quality films were obtained…

This paper presents the development of scientific instrumentation for the fabrication of ferromagnetic thin films, by sputtering technique, for the use of 2-inch-diameter targets. Thin films were deposited using Permalloy alloy (Ni80Fe20)…

We report the results of GIXRR, UV-VIS NIR and XPS measurements on Si and Ge thin films of various thicknesses. While GIXRR measurements show no presence of oxide on the top of these films, XPS measurements show small amount of oxides.…

Magnetron sputtering has also been used to deposit thin films of some materials and it has significant technological importance. A modeling on deposition of epitaxial thin films of Yttrium Stabilized Zirconia (YSZ) was done the diffusion of…

Technological advancements are strongly required to fulfill the demands of new accelerator devices with the highest accelerating gradients and operation reliability for the future colliders. To this purpose an extensive R&D regarding…

We studied the growth behavior, structural, electronic, and magnetic properties of cobalt nitride (Co-N) thin films deposited using direct current (dc) and high power impulse magnetron sputtering (HiPIMS) processes. The N$_2$ partial gas…

Micron-thick boron films have been deposited by Pulsed Laser Deposition in vacuum on several substrates at room temperature. The use of high energy pulses (>700 mJ) results in the deposition of smooth coatings with low oxygen uptake even at…

The broadband microstrip ferromagnetic resonance technique has been applied for detection and characterization of a magnetic inhomogeneity in a film sample. In the case of a 100nm thick Permalloy film an additional magnetically depleted top…

In this work, we studied cobalt nitride (Co-N) thin films deposited using a dc magnetron sputtering method at a substrate temperature (\Ts) of 523\,K. We find that independent of the reactive gas flow (\pn) used during sputtering, the…

Growth optimization of multilayers is a topic of interest due to their unique physical properties. Systems containing magnetic materials, such as platinum-cobalt, have been studied because of their potential for technological applications,…

We report the reduction in residual stress of AlN thin films and also the crystal structure, surface morphology and nanomechanical properties of magnetron sputtered as a function of substrate temperature (Ts, 35 - 600 ?C). The residual…

SrFe$_{12}$O$_{19}$ (SFO) films grown on Si (100) substrates by radio-frequency magnetron sputtering have been characterized in terms of composition, structural and magnetic properties by a combination of microscopy, diffraction and…