相关论文: The CMS Tracker Readout Front End Driver

In this paper, the SHIP4LLRF (Scalable Hardware Integrated Platform for LLRF) based on 6U VPX-standard was designed preliminarily, which includes 6U mother board and two HPC FPGA mezzanine cards (FMCs). The ADC and DAC FMC is based on…

Silicon carbide (SiC) has been widely adopted in the semiconductor industry, particularly in power electronics, because of its high temperature stability, high breakdown field, and fast switching speeds. Its wide band gap makes it an…

The Xilinx ZCU111 Radio Frequency System on Chip (RFSoC) is a promising solution for reading out large arrays of microwave kinetic inductance detectors (MKIDs). The board boasts eight on-chip 12-bit / 4.096 GSPS analogue-to-digital…

The Phase-II Upgrade of the ATLAS Muon Detector requires new electronics for the readout of the MDT drift tubes. The first processing stage, the Amplifier-Shaper-Discriminator (ASD), determines the performance of the readout for crucial…

We present the design, fabrication, and measurement of a monolithically integrated optical receiver analog front end, where low power operation is a primary consideration with a goal of supporting 56 Gbaud intensity modulated direct detect…

Large liquid argon Time Projection Chambers have been adopted for the DUNE experiment's far detector, which will be composed of four 17 kton detectors situated 1.5 km underground at the Sanford Underground Research Facility. This represents…

A dedicated front-end electronics has been developed for the trigger chambers of the ALICE muon spectrometer which will work at the future LHC at CERN. These trigger chambers are based on RPCs (Resistive Plate Chambers) working in streamer…

In preparation for the High Luminosity LHC, the entire tracker detector of the CMS experiment will be exchanged as part of the Phase-2 Upgrade. The new Outer Tracker will comprise approximately 13,000 silicon sensor modules, of which 7608…

At SRON we have been developing X-ray TES micro-calorimeters as backup technology for the X-ray Integral Field Unit (X-IFU) of the Athena mission, demonstrating excellent resolving powers both under DC and AC bias. We also developed a…

We have operated a Medipix2 CMOS readout chip, with amplifying, shaping and charge discriminating front-end electronics integrated on the pixel-level, as a highly segmented direct charge collecting anode in a three-stage gas electron…

Many accelerators require considerable electronic systems for tests, verification, and operation. In Shenzhen Superconducting Soft X-ray Free Electron Laser (S3FEL), to meet the early tests and verification of various systems, save…

One of the optimization goals of a particle accelerator is to reach the highest possible beam peak current. For that to happen the electron bunch propagating through the accelerator should be kept relatively short along the direction of its…

The Silicon Tracker (STK) is a detector of the DAMPE satellite to measure the incidence direction of high energy cosmic ray. It consists of 6 X-Y double layers of silicon micro-strip detectors with 73,728 readout channels. It's a great…

High luminosity conditions at the LHC pose many unique challenges for potential silicon based track trigger systems. One of the major challenges is data formatting, where hits from thousands of silicon modules must first be shared and…

A MHz frame rate X-ray area detector (LPD - Large Pixel Detector) is under development by the Rutherford Appleton Laboratory for the European XFEL. The detector will have 1 million pixels and allows analogue storage of 512 images taken at…

Affine frequency division multiplexing (AFDM), an emerging multi-carrier modulation scheme, has garnered significant attention due to its resilience to Doppler shifts and capability to achieve full diversity in doubly dispersive channels.…

The phase 1 upgrade of the CMS pixel detector has been designed to maintain the tracking performance at instantaneous luminosities of $2 \times 10^{34} \mathrm{~cm}^{-2} \mathrm{~s}^{-1}$. Both barrel and endcap disk systems now feature one…

The CMS experiment will collect data from the proton-proton collisions delivered by the Large Hadron Collider (LHC) at a centre-of-mass energy up to 14 TeV. The CMS trigger system is designed to cope with unprecedented luminosities and LHC…

To assess the viability of a shallow-depth neutrino detector, a Cosmic Muon Veto Detector (CMVD) is being constructed on top of the stack of Resistive Plate Chamber (RPC) detectors at TIFR, Mumbai. The CMVD employs extruded plastic…

Perceptive mobile networks implement sensing and communication by reusing existing cellular infrastructure. Cell-free multiple-input multiple-output, thanks to the cooperation among distributed access points, supports the deployment of…