相关论文: Beam-Based Determination of the Offset of Booster …

There are more than 15 years since the transition-jump system (TJS) was installed. Because of the quad steering, which is caused by the beam not being well centered through all the gamma-T quads, the TJS has never been used in the…

A feed-forward ramp can be implemented in Booster to compensate the beam energy loss at different beam intensities for the purpose of minimizing the radial error signal. This can be done only when we have a good understanding about the…

To make full use of photocathode material and improve its quantum efficiency lifetime, it can be necessary to operate laser away from the cathode center in photoinjectors. In RF guns, the off-axis emitted beam will see a time-dependent RF…

Understanding the transition-crossing process is crucial for improving Booster performance at high intensity. The synchronous phase appears to drop toward 90 degrees right after transition regardless of beam intensity, more so at higher…

The bunch-by-bunch BPM signal array has to be reshaped into a turn-by-turn (TBT) matrix in order to make the TBT beam position information of a single bunch available for further data analysis, such as via the Fourier transform to obtain…

Time-resolved atom interferometry, as employed in applications such as gravitational wave detection and searches for ultra-light dark matter, requires precise control over systematic effects. In this work, we investigate phase noise arising…

We have used the ROSAT High Resolution Imager to search for quiescent X-ray counterparts to four gamma-ray bursts which were localized to small (< 10 sq. arcmin.) error boxes with the Interplanetary Network. The observations took place…

The High Intensity Gamma-ray Source (HIGS) at Duke University is an accelerator-driven Compton gamma-ray source, providing high flux gamma-ray beam from 1 MeV to 100 MeV for photo-nuclear physics research. The HIGS facility operates three…

It is important to improve the frequency tracking between the RF drive and the cavity field for the purpose of reducing longitudinal phase oscillations and increasing the effective accelerating voltage. And this is especially beneficial for…

Compact binary millisecond pulsars (also known as spiders) allow us to probe pulsar winds in their innermost regions, between the light cylinder (radius $\sim10^{7}$ cm) and the companion star (at $\sim10^{11}$ cm). Their flux is known to…

The undulator line of the Shanghai soft X-ray Free-electron Laser facility (SXFEL) has very tight tolerances on the straightness of the electron beam trajectory. However, the beam trajectory cannot meet the lasing requirements due to the…

The gamma-ray burst's lightcurves have been analyzed using a special wavelet transformation. The applied wavelet base is based on a typical Fast Rise-Exponential Decay (FRED) pulse. The shape of the wavelet coefficients' total distribution…

Beam position monitor (BPM) can easily reinforce the handling of beam orbits and measure the absolute beam position [1]. Its data can be used to optimize and correct beam in both first turn and closed orbit mode. In order to set the…

Since a wider aperture has been obtained along the Booster beam line, this opens the opportunity for Booster running a higher intensity beam than ever before. Sooner or later, the available RF accelerating voltage will become a new limit…

Closed orbit feedback (COFB) systems used for the global orbit correction rely on the pseudo-inversion of the orbit response matrix (ORM). A mismatch between the model ORM used in the controller and the actual machine ORM can affect the…

Light travel time changes due to gravitational waves may be detected within the next decade through precision timing of millisecond pulsars. Removal of frequency-dependent interstellar medium (ISM) delays due to dispersion and scattering is…

We present the results of numerical simulations of the prompt emission of short-duration gamma-ray bursts. We consider emission from the relativistic jet, the mildly relativistic cocoon, and the non-relativistic shocked ambient material. We…

Quantum phase transitions (QPTs) in the spin-boson model with/without the rotating-wave approximation (RWA) are systematically investigated through variational calculations using a sub-Ohmic bath with high spectral density. Four cases…

Context. Multi-element phased-array radio telescopes use digital beamforming to widen their field-of-view with numerous tied-array beams (TABs). These beams share bandpass variations and radio frequency interference (RFI). Yet, most pulsar…

Measurement of a jet geometry transition region is an important instrument of assessing the jet ambient medium properties, plasma bulk motion acceleration, parameters of a black hole and location of a jet launching radius. In this work we…