相关论文: Novel Data Acquisition System for Silicon Tracking…
A digital data acquisition system (DDAS) has been implemented for the Low Energy Neutron Detector Array (LENDA). LENDA is an array of 24 BC-408 plastic-scintillator bars designed to measure low-energy neutrons with kinetic energies in the…
The evolution of particle detectors has always pushed the technological limit in order to provide enabling technologies to researchers in all fields of science. One archetypal example is the evolution of silicon detectors, from a system…
We are developing DAQ for Si-pixel detectors by using a Slicon-On-Insulator (SOI) technology. This DAQ consists of firmware works on SEABAS (Soi EvAluation BoArd with Sitcp) DAQ board and software works on PC. We have been working on the…
Microwave reflectometry is a non-intrusive plasma diagnostic tool which is widely applied in many fusion devices. In 2014, the microwave reflectometry on Experimental Advanced Superconducting Tokamak (EAST) had been upgraded to measure…
The Data Acquisition System of the LZ experiment, the 10-tonne dark matter detector to be installed at the Sanford Underground Research Facility (SURF), will collect signals from 788 photomultiplier tubes (PMTs). Because the signals from…
Beam measurement is very important for accelerators. With the development of analog-to-digital conversion techniques, digital beam measurement becomes a research hot spot. IQ (In-phase & Quadrature-phase) analysis based method is an…
The rigorous analysis of specialized physical processes often demands custom data acquisition architectures that offer flexibility and precision beyond the capabilities of general-purpose commercial loggers. This paper presents the design…
New front-end electronics including ASICs and FPGA boards are under development for the ATLAS Monitored Drift Tube (MDT) detector to handle the large data rates and harsh environment expected at high-luminosity LHC runs. A mobile Data…
We report a mixed-signal data acquisition (DAQ) system for optically detected magnetic resonance (ODMR) of solid-state spins. This system is designed and implemented based on a Field-Programmable-Gate-Array (FPGA) chip assisted with…
In Phase II of the Project 8 neutrino mass experiment, electrons from the decays of tritium or ${}^{83\mathrm{m}}$Kr are detected via their $\approx$26 GHz cyclotron radiation while contained within a circular waveguide. The signal from a…
A low-cost, stand-alone Global-Positioning-System-time-synchronized data acquisition system is described. The constructed prototype allows recoding up to four analog signals with a 16-bit resolution in variable ranges and a maximum sampling…
In this paper, we describe a modular data acquisition system developed as the foundation of a cosmic ray detector network. Each detector setup (henceforth referred as a station) is composed of an independent hardware device that can be…
We have built a high precision (24-bit) data acquisition (DAQ) system with eight simultaneously sampling input channels for the measurement of the electric dipole moment (EDM) of the electron. The DAQ system consists of two main components,…
High-energy cosmic rays are one of the primary sources of information for scientists investigating the elementary properties of matter. The need to study cosmic rays, with energies thousands of times larger than those encountered in…
The TRISTAN detector is an upgrade to the KATRIN experiment to enable a differential measurement of the tritium $\beta$-decay spectrum to search for the experimental signature of keV scale sterile neutrinos. The TRISTAN detector upgrade…
A new data acquisition system for the high resolution magnetic spectrometer Lintott at the superconducting Darmstadt electron linear accelerator S-DALINAC was developed. It allows inclusive and coincidence electron scattering experiments…
The time-of-flight (TOF) system in the Compressed Baryonic Matter (CBM) experiment is composed of super modules based on multi-gap Resistive Plate Chambers (MRPC) for high-denseness, high-resolution time measurement. In order to evaluate…
The Spin Physics Detector (SPD) experiment at the NICA collider in JINR aims to investigate the spin structure of nucleons and spin-related phenomena. The combination of the number of background processes, the event rate and conditions for…
Although CMS will not start operation for several years, many subdetector groups have active testbeam programs involving final or near-final electronics. The high-bandwidth electronics require the development of new DAQ systems including…
We summarize the R&D activities on a novel semitransparent microstrip sensor to be used on laser-based alignment systems for silicon trackers. The new sensor is used both for particle tracking and laser detection. The aim of this research…