相关论文: Upgrade of the SDL Control System

The Pohang Accelerator Laboratory operates an electron linac for the pulsed neutron source as one of the long-term nuclear R&D programs at the Korea Atomic Energy Research Institute. The designed beam parameters are as follows; The nominal…

On the wake of the results obtained so far at the SPARC\_LAB test-facility at the Laboratori Nazionali di Frascati (Italy), we are currently investigating the possibility to design and build a new multi-disciplinary user-facility, equipped…

The first version of digital low level RF (DLLRF) for the Diamond Light Source storage ring and booster was developed with ALBA Synchrotron. Six systems have been built so far. Two of them are in routine operation controlling two normal…

The High Energy Photon Source (HEPS), is the first fourth-generation storage ring light source being built in the suburb of Beijing, China. The storage ring was designed with the emittance lower than 60 pm.rad with a circumference of 1.36…

The LHeC provides an intense, high energy electron beam to collide with the LHC. It represents the highest energy application of energy recovery linac (ERL) technology which is increasingly recognized as one of the major pilot technologies…

Purpose: In this study, procedures were developed to achieve efficient reversible conversion of a clinical linear accelerator (LINAC) and deliver electron FLASH (eFLASH) or conventional beams to the treatment room isocenter. Material &…

A superconducting linear accelerator operating in continuous-wave mode could produce X-ray free electron lasers (XFEL) at megahertz repetition rate, with the capability that delivering wide spectral range coherent radiation to multi end…

We report on the development, implementation, and characterization of digital controllers for laser frequency stabilization as well as intensity stabilization and control. Our design is based on the STEMlab (originally Red Pitaya) platform.…

The LIGO Interferometer Sensing and Control System (ISC) is a large and highly distributed Multiple Input Multiple Output (MIMO) control system that is used to control the length and alignment degrees of freedom of the interferometers. The…

The timing system of the Swiss Light Source is based on the event system concept of APS, Argonne [1]. However, for SLS the hardware was completely redesigned while preserving the software compatibility with the APS system. This gave us a…

Over the last two decades, spatial light modulators (SLMs) have revolutionised our ability to shape optical fields. They grant independent dynamic control over thousands of degrees-of-freedom within a single light beam. In this work we test…

This conceptual design report provides a detailed account of the European Spallation Source neutrino Super Beam (ESS$\nu$SB) feasibility study. This facility has been proposed after the measurements reported in 2012 of a relatively large…

Microelectronic integration is a key enabler for the ubiquitous deployment of devices in large volumes ranging from MEMS and imaging sensors to consumer electronics. Such integration has also been achieved in photonics, where compact…

The Santa Cruz Extreme AO Lab (SEAL) is a new visible-wavelength testbed designed to advance the state of the art in wavefront control for high contrast imaging on large, segmented, ground-based telescopes. SEAL provides multiple options…

The National Ignition Facility (NIF) requires that pulses from each of the 192 laser beams be positioned on target with an accuracy of 50 um rms. Beam quality must be sufficient to focus a total of 1.8 MJ of 0.351-um light into a…

A new instrument for spot profile analysis of electron diffraction - SPA-LEED - has been set up. The instrument works either with a transparent phosphor screen for visual inspection of the pattern or in its main mode with a channeltron for…

Controlling matter at the level of electrons using ultrafast laser sources represents an important challenge for science and technology. Recently we introduced a general laser control scheme (the Stark Control of Electrons at Interfaces or…

We report results of the beam commissioning and first operation of the 1.3 GHz superconducting RF electron linear accelerator at Fermilab Accelerator Science and Technology (FAST) facility. Construction of the linac was completed and the…

The upgrade for ATLAS detector will undergo different phase towards super-LHC. The first upgrade for the Pixel detector will consist of the construction of a new pixel layer which will be installed during the first shutdown of the LHC…

The Fermi National Accelerator Laboratory (FNAL) Linac has been in operation for 52 years. In approximately four years, it will be replaced by a new 800 MeV superconducting machine, the PIP-II SRF Linac. In the current configuration, the…