相关论文: Injection Control System of HLS Storage Ring

HLS (Hefei Light Source) is a second generation synchrotron radiation source. After injected into the storage ring at energy of 200MeV, the electrons will be ramped to 800MeV. During ramping, the magnetic fields of the bend, quadruple and…

To meet the increasing requirements of synchrotron radiation users, the upgrade project to enhance the performance of Hefei Light Source (HLS), named HLS-II, was launched in 2010, and in 2014 the first commissioning of HLS-II was…

The control system of the 1.5 MeV FEL injector is built on the base of ported EPICS. It uses low-cost hardware: personal computers with the processor Intel x86 and CAMAC equipment produced by our institute. At present time, the distributed…

Louisiana State University Center for Advanced Microstructures and Devices (CAMD) began a control system upgrade project in early 1997. At the time, the storage ring was controlled by a VAX/VMS system, primarily using CAMAC for I/O. The…

The SNS Project intends to integrate Conventional Facility Controls with its EPICS-based Accelerator and Target Control Systems. EPICS will therefore be used to provide distributed high-level access to all subsystems of the SNS conventional…

Recently the Chinese Academy of Sciences has chosen BEPCII as the future development of the BEPC, i.e. upgrade of both the machine and detector. The luminosity of the machine is expected to increase to 1.0x1033cm-2s-1. The project will be…

The commissioning of the Swiss Light Source (SLS) started in Feb. 2000 with the Linac, continued in May 2000 with the booster synchrotron and by Dec. 2000 first light in the storage ring were produced. The first four beam lines had to be…

The PEP-II storage rings at SLAC each have 3492 'buckets' into which electrons and positrons can be injected into the high- and low-energy rings. Equipment to measure the currents of all the individual buckets was originally provided by the…

The High Energy Photon Source (HEPS), is the first fourth-generation storage ring light source being built in the suburb of Beijing, China. The storage ring was designed with the emittance lower than 60 pm.rad with a circumference of 1.36…

The Integrated Computer Control System (ICCS) for the National Ignition Facility (NIF) is a layered architecture of 300 front-end processors (FEP) coordinated by supervisor subsystems including automatic beam alignment and wavefront…

Industrial control system (ICS) operations use trusted endpoints like human machine interfaces (HMIs) and workstations to relay commands to programmable logic controllers (PLCs). Because most PLCs lack layered defenses, compromise of a…

The Source Development Lab (SDL) at BNL consists of a 230 MeV electron linac and a 10 m long wiggler for short wavelength Free Electronic Laser (FEL) development. The original control system [1] was based on the one in use at the National…

The Advanced Light Source (ALS) at Lawrence Berkeley National Laboratory, a third-generation synchrotron light source operational since 1992, is undergoing a comprehensive upgrade of its storage ring RF control system. The legacy Horner PLC…

The EPICS based control system of the ISAC radioactive beam facility supervises several sub-systems, which are controlled by PLCs. Most of the devices are protected by non-trivial interlocks, which are implemented with ladder-logic…

At the High Energy Photon Source (HEPS) where up to 90 beamlines can be provided in the future, minimisation of workload for individual beamlines and maximisation of knowledge about one beamline that can be applied to other beamlines is…

After the CSNS ion source test stand has been stably working for years, an online control system for CSNS ion source aiming to be more stable and reliable is now under development. F3RP61-2L, a new PLC CPU module under Linux system, is…

The Advanced Photon Source is now in its fifth year of routine beam production. The EPICS-based [1] control system has entered the phase in its life cycle where new control algorithms must be implemented under increasingly stringent…

Programmable Logic Controllers (PLCs) are the core control devices in Industrial Control Systems (ICSs), which control and monitor the underlying physical plants such as power grids. PLCs were initially designed to work in a trusted…

Experimental Physics and Industrial Control System (EPICS) is a software tool that during last years has become relevant as a main framework to deploy distributed control systems in large scientific environments. At the moment, ESS Bilbao…

We present a slow control system to gather all relevant environment information necessary to effectively and reliably run an HPC (High Performance Computing) system at a high value over price ratio. The scalable and reliable overall concept…