相关论文: Front End CAMAC Controller for SLAC Control System

We will use EPICS toolkit [1] to build a prototype for upgrading BEPC control system. The purposes are for the following three aspects: (1) Setup a network based distributed control system with EPICS. (2) Study some front-end control…

A pipeline CAMAC controller with PC/104-Plus single board computer has been developed. The architecture of the pipeline CAMAC controller is completely different from that of traditional CAMAC controller. The pipeline CAMAC controller…

Louisiana State University Center for Advanced Microstructures and Devices (CAMD) began a control system upgrade project in early 1997. At the time, the storage ring was controlled by a VAX/VMS system, primarily using CAMAC for I/O. The…

This report concerns the present status of VEPP-5 control system. The control system hardware consists of CAMAC blocks, a set of crate controllers based on INMOS transputers and ICL-1900 architecture processor Odrenok, and Pentium-based…

This work describes the LLRF and control system in use for a novel accelerator structure developed for a compact design operating in C-band developed by SLAC, with collaboration from RadiaBeam and RadiaSoft. This design is a pulsed…

A new data acquisition program for personal computers with Windows operating system has been built at Charles University van de Graaff laboratory. It allows fast data acquisition from CAMAC and other PC interface cards using interrupt or…

Model Predictive Control (MPC) is a computationally demanding control technique that allows dealing with multiple-input and multiple-output systems, while handling constraints in a systematic way. The necessity of solving an optimization…

The linear accelerator (LINAC) at the Los Alamos Neu-tron Science Center (LANSCE) consists of Pre-buncher, Main-Buncher, low-energy beam transport (LEBT), four 201.25-MHz Drift Tube Linacs (DTLs) and forty-four 805-MHz Coupled Cavity Linacs…

The Integrated Computer Control System (ICCS) for the National Ignition Facility (NIF) is a layered architecture of 300 front-end processors (FEP) coordinated by supervisor subsystems including automatic beam alignment and wavefront…

Efficient operation of a submillimeter interferometer requires remote (preferably automated) control of mechanically tuned local oscillators, phase-lock loops, mixers, optics, calibration vanes and cryostats. The present control system for…

The SRS is a 2GeV synchrotron light source with 14 beamlines serving approximately 34 experimental stations. Control of the major elements of the beamlines (vacuum pumps, gauges, valves and radiation stops) is the responsibility of the main…

We have designed, fabricated and operated a scalable system for applying independently programmable time-independent, and limited time-dependent flux biases to control superconducting devices in an integrated circuit. Here we report on the…

To meet the demands of future wireless networks, antenna arrays must scale from massive multiple-input multiple-output (MIMO) to gigantic MIMO, involving even larger numbers of antennas. To address the hardware and computational cost of…

The EPICS based control system of the ISAC radioactive beam facility supervises several sub-systems, which are controlled by PLCs. Most of the devices are protected by non-trivial interlocks, which are implemented with ladder-logic…

The Low-Level RF (LLRF) control circuits of linear accelerators (LINACs) are conventionally realized with heterodyne based architectures, which have analog RF mixers for up and down conversion with discrete data converters. We have…

High energy physics experiments in KEK/Japan rush into over KHz trigger stage. Thus, we need a successor of the data acquisition(DAQ) system that replaces the CAMAC or FASTBUS systems. To meet these needs, we have developed a DAQ system…

We integrated an injector linac control system to the SPring-8 standard system on September 2000. As a result of this integration, the SPring-8 accelerator complex was controlled by one unified system. Because the linac was continuously…

Implementation and commissioning of the EPICS based control system for the ISAC radioactive beam facility was completed. The target ion source, mass separator, and low-energy beam-lines started beam production for experiments. In parallel,…

This paper investigates a Stacked Intelligent Metasurfaces (SIM)-assisted Integrated Sensing and Communications (ISAC) system. An extended target model is considered, where the BS aims to estimate the complete target response matrix…

Electronic control systems used for quantum computing have become increasingly complex as multiple qubit technologies employ larger numbers of qubits with higher fidelity targets. Whereas the control systems for different technologies share…