相关论文: New 357 MHz Sub Harmonic Buncher

Dedicated optics with extremely short electron bunches enable synchrotron light sources to generate intense coherent THz radiation. The high degree of spatial compression in this so-called low-alpha optics entails a complex longitudinal…

High-power electron beams are sought-after tools in support to a wide array of societal applications. This paper investigates the production of high-power electron beams by combining a high-current field-emission electron source to a…

In order to double the positron injection rate into the KEKB ring, a two-bunch acceleration scheme has been studied at the linac, in which bunches separated by 96 ns are accelerated in 50 Hz. In this scheme the stabilization of energy and…

We propose and demonstrate a novel method to produce few-femtosecond electron beam with relatively low timing jitter. In this method a relativistic electron beam is compressed from about 150 fs (rms) to about 7 fs (rms, upper limit) with…

A bunching system is proposed for the initial stage of CTF3 which consists of one (two) 3 GHz prebunchers and one 3 GHz travelling wave (TW) buncher with variable phase velocities. The electron beam is emitted from a 140 KV DC gun. Since…

The main `bottleneck' limiting the beam power in circular machines is caused by space charge effects that produce beam instabilities. To increase maximally the beam power of a `proton driver', it is proposed to build a facility consisting…

The CLIC Test Facility (CTF3) is an intermediate step to demonstrate the technical feasibility of the key concepts of the new RF power source for CLIC. CTF3 will use electron beams with an energy range adjustable from 170 MeV (3.5 A) to 380…

We propose and demonstrate a novel scheme to produce ultrashort and ultrastable MeV electron beam. In this scheme, the electron beam produced in a photocathode radio-frequency (rf) gun first expands under its own Coulomb force with which a…

A 52MHz Radio Frequency Quadrupole (RFQ) linear accelerator (linac) is designed to serve as an initial structure for the SSC-linac system (injector into Separated Sector Cyclotron). The designed injection and output energy are 3.5 keV/u and…

Interest in highly-compressed electron beams has been increasing in recent times, driven by the study of non-linear and even non-perturbative aspects of QED [2]. The FACET-II [7] facility at SLAC is currently (at the time of writing) being…

At KARA, the KArlsruhe Research Accelerator of the KIT synchrotron, the so called short bunch operation mode allows the reduction of the bunch length down to a few picoseconds. The micro- bunching instability resulting from the high degree…

A higher harmonic cavity (HHC), used to cause bunch lengthening for an increase in the Touschek lifetime, is a feature of several fourth generation synchrotron light sources. The desired bunch lengthening is complicated by the presence of…

We construct a new detector to monitor $\gamma$ yields in bunch by bunch basis for the Laser Compton experiment at the KEK ATF which is capable to separate $\gamma$ rays in 5.6ns-spacing multi-bunch operation of the KEK ATF. In this article…

A magnetic bunch compressor has been designed and is being commissioned for the APS linac to provide higher peak current for the LEUTL FEL. Of primary concern is control of emittance growth due to coherent synchrotron radiation (CSR). In…

We present the first theoretical results on the generation of short-wavelength attosecond vortex beams in semiconductors through their interactions with an intense Laguerre-Gauss beam, in the limit where non-perturbative high-order…

With electron beam durations down to femtoseconds and sub-femtoseconds achievable in current state-of-the-art accelerators, longitudinal bunch length diagnostics with resolution at the attosecond level are required. In this paper, we…

A new laser-wire is being installed in the extraction line of the ATF at KEK. This device aims at demonstrating that laser-wires can be used to measure micrometre scale beam size.

The development of Ultra-High Frequency (UHF) linear accelerators via Metal Additive Manufacturing (MAM) is a strategic research focus of the RACERS team at GSI. The 704.4 MHz Crossbar H-mode (CH) cavity, proposed in 2021 to facilitate…

Electron accelerators and synchrotrons can be operated to provide short emission pulses due to longitudinally compressed or sub-structured electron bunches. Above a threshold current, the high charge density leads to the micro-bunching…

This paper describes the development progress of high current superconducting RF linacs in Los Alamos, performed to support a design of the linac for the APT (Accelerator Production of Tritium) Project. The APT linac design includes a CW…