相关论文: Air entrainment through free-surface cusps
We study, from first principles, the pressure exerted by an active fluid of spherical particles on general boundaries in two dimensions. We show that, despite the non-uniform pressure along curved walls, an equation of state is recovered…
The phenomenon of crumpling is common in our daily life and nature. It exhibits many interesting properties, such as ultra-tough resistance to pressure with less than 30$\%$ of volume density, power-law relation for pressure vs density, and…
A mechanism of formation of small-scale inhomogeneities in spatial distributions of aerosols and droplets associated with clustering instability in the atmospheric turbulent flow is discussed. The particle clustering is a consequence of a…
We study two new models of two particle species invading a surface from opposite sides. Collisions of particles of different species lead to the formation of congestion fronts. One of the models implements a reversible process whereas in…
A slender object undergoing an axial compression will buckle to alleviate the stress. Typically the morphology of the deformed object depends on the bending stiffness for solids, or the viscoelastic properties for liquid threads. We study a…
This paper explores the fluid-elastic response of a cantilevered flexible sheet in the presence of uniform airflow. The leading edge of the sheet is clamped, while at the trailing edge, in-plane tension is applied to provide additional…
The complex interactions between turbulence and the free surface, including air entrainment processes, in boundary layer shear flows created by vertical surface-piercing plates are considered. A laboratory-scale device was built that…
We present accurate measurements of the relative motion and deformation of two large bubbles released consecutively in a quiescent liquid confined in a thin-gap cell. Though the second bubble injected is smaller, we observed that in all…
The Cellular Potts Model (CPM) succesfully simulates drainage and shear in foams. Here we use the CPM to investigate instabilities due to the flow of a single large bubble in a dry, monodisperse two-dimensional flowing foam. As in…
A novel mechanism of the formation of compact dusty clouds in astrophysical environments is discussed. It is shown that the balance of collective forces operating in space dusty plasmas can result in the effect of dust self-confinement,…
The sorption-desorption hysteresis observed in many nanoporous solids, at vapor pressures low enough for the the liquid (capillary) phase of the adsorbate to be absent, has long been vaguely attributed to changes in the nanopore structure,…
A liquid jet plunging into a quiescent bath of the same liquid is a fundamental fluid mechanical problem underpinning a range of processes in industry and the natural world. Significant attention has been given to the study of plunging…
The present work investigates the internal flow structure of two condensing droplets of aqueous solution during interaction. The velocity of fluid inside the droplets was investigated by confocal micro-PIV technique. Condensation on the…
The process of formation for an ice crystal with elaborate, symmetrical patterns from the water vapor is usually complicated and the corresponding mechanism is still not clear. Here, we experimentally constructed the 3D tubular ice crystals…
A granular instability driven by gravity is studied experimentally and numerically. The instability arises as grains fall in a closed Hele-Shaw cell where a layer of dense granular material is positioned above a layer of air. The initially…
The dynamics of saturated vapor between two intersecting walls is examined. It is shown that, if the angle $\phi$ between the walls is sufficiently small, the vapor becomes unstable, and spontaneous condensation occurs in the corner,…
We study, by direct numerical simulations in two and three dimensions, the instability caused by the settling and evaporation of water droplets out of a cloudy layer saturated with vapour into a dry sub-cloud ambient, under conditions where…
The process of bubble formation from an orifice submerged in liquid with constant gas flow is studied by numerical simulations using an OpenFOAM volume-of-fluid solver named interIsoFoam. The computed results show that the detached bubble…
Concept of curvature of liquid surrounding a spherical surface seems obvious in daily life, but based on earthly conditions everywhere. However, our understanding about the concept seems more transparent when we keep the system out of the…
The dynamical perspectives of bubble in a liquid droplet on smooth solid substrate can be revealed by investigating interfacial self-assembly phenomena. Moreover, the complexity in such system can be scaled down into a transparent immobile…