相关论文: Magnetic Properties of Fe75Cu4Ni4Mo2B15 Alloy

The study of the magnetic properties depending upon mechanical milling of the ferromagnetic polycrystalline TbAl_2 material is reported. The Rietveld analysis of the X-ray diffraction data reveals a decrease of the grain size down to 14 nm…

The effect of the short milling times on R5(Si,Ge)4 R =Gd, Tb magnetocaloric material properties was investigated. In particular, the effect of milling on atomic structure, particles size and morphology, magnetic, and magnetocaloric effect…

The magnetization of Ni_{1-x}Mo_{x} single crystals with x=4,6,8 and 10 % by weight have been measured at 4.2K using a vibrating sample magnetometer and a Superconducting Quantum Interference Device (SQUID). The magnetization of the alloy…

We have investigated the magnetic behavior of ball-milled fine particles of well-known Kondo lattices, CeAu2Si2, CePd2Si2 and CeAl2, by magnetization and heat-capacity studies in order to understand the magnetic behavior when the particle…

In this work we report a study of the magnetic behavior of ferrimagnetic oxide CoFe2O4 treated by mechanical milling with different grinding balls. The cobalt ferrite nanoparticles were prepared using a simple hydrothermal method and…

We investigate the magnetoelastic properties of $\mathrm{Co_{25}}\mathrm{Fe_{75}}$ and $\mathrm{Co_{10}}\mathrm{Fe_{90}}$ thin films by measuring the mechanical properties of a doubly clamped string resonator covered with multi-layer stacks…

The effect of ball milling on the structural, magnetic and exchange bias properties of Ni50Mn36Fe2Sb12 Heusler alloys was studied. The ball milled samples exhibited coexisting austenite and martensite phases at room temperature, while…

Despite intense research in the field of strongly correlated electron behavior for the past few decades, there has been very little effort to understand this phenomenon in nano particles of the Kondo lattices. In this article, we review the…

Magneto-impedance (MI) effects have been observed for amorphous Fe73.5Nb3Cu1Si13.5B9 ribbon which has been excited by an a.c. magnetic field parallel to the length of the ribbon. Maximum relative change in MI as large as -99% was observed…

Spinel Fe3O4 nanoparticles have been produced through ball milling in methyl-alcohol (CH3OH), aiming to obtain samples with similar average particle sizes <d> and different interparticle interactions. Three samples having Fe3O4/CH3(OH) mass…

Magnetization reversal of individual, isolated high-aspect-ratio Fe nanoparticles with diameters comparable to the magnetic exchange length is studied by high-sensitivity submicron Hall magnetometry. For a Fe nanoparticle with diameter of 5…

Flake-shaped FeSi-based metallic amorphous alloy particles, having an aspect ratio as high as 175 to 1, were prepared by ball milling gas atomized amorphous powders of an effective diameter of 20 micrometers. The starting powder had a…

We present X-ray diffraction (XRD), M\"ossbauer spectroscopy (MS) and d.c. magnetization measurements performed on ball-milled CuFe2O4 samples. The average particle size <d> was found to decrease to the nanometer range after t=15 min of…

The effects of the crystalline symmetry on the magnetotransport properties in ferromagnetic alloys are being reexamined in recent years particularly due to the role of the anisotropic magnetoresistance on the electrical detection of…

Magnetic properties of thin films differs from that of the corresponding bulk materials and show novel physics as a result of their reduced size and dimensionality. Profound changes in magnetic properties can also result with exchange bias…

Magnetic susceptibility of the isostructural Ce(Ni{1-x}Cu{x})5 alloys (0< x <0.9) was studied as a function of the hydrostatic pressure up to 2 kbar at fixed temperatures 77.3 and 300 K, using a pendulum-type magnetometer. A pronounced…

We succeeded in the synthesis of high-Jc MgB2 bulks via high energy ball-milling of elemental Mg and B powder at ambient temperatures. Alternatively to longtime mechanical alloying technique, the mixed powder was ball-milled for only 1h and…

Electrical conductivity, thermopower and magnetic properties of Fe-intercalated Fe0.33VSe2 has been reported between 4.2K - 300K. We observe a first order transition in the resistivity of the sintered pellets around 160K on cooling. The…

The crystal and magnetic structure of the magnetocaloric compound FeMnP0.5Si0.5 have been studied by means of neutron and X-ray powder diffraction. Single phase samples of nominal composition FeMnP0.5Si0.5 have been prepared by the drop…

High quality stoichiometric magnetite (Fe3O4) films grown by infrared pulsed laser deposition (IR-PLD) on different surfaces were investigated in order to study the influence of the substrate, orientation, and thickness on their magnetic…