相关论文: Fringe Visibility Estimators for the Palomar Testb…

The Palomar Testbed Interferometer (PTI) is a long-baseline infrared interferometer located at Palomar Observatory, California. It was built as a testbed for interferometric techniques applicable to the Keck Interferometer. First fringes…

The Palomar Testbed Interferometer (PTI) archive of observations between 1998 and 2005 is examined for objects appropriate for calibration of optical long-baseline interferometer observations - stars that are predictably point-like and…

This tutorial gives a general introduction to optical and infrared interferometry, specifically addressing two questions: `Can I use VLTI to observe my favourite object?' and `What will it tell me?' The observables measured by an…

Measurement of interferometric parameters values is affected by phase disturbance due especially to atmospheric turbulences. Algorithms of fringe sensing, aimed at fringe parameters identification, are based on interferometric models that…

There are several solutions to code the signal arising from optical long baseline multi-aperture interferometers. In this paper,we focus on the {\bf non homothetic spatial coding scheme} (multiaxial) with the fringe pattern coded along one…

Optical interferometers increasingly use single-mode fibers as spatial filters to convert varying wavefront distortion into intensity fluctuations which can be monitored for accurate calibration of fringe amplitudes. Here I propose using an…

In this paper we compare the performance of multi and single-mode interferometry for the estimation of the phase of the complex visibility. We provide a theoretical description of the interferometric signal which enables to derive the phase…

AIMS: We have found that the interferometric visibilities of VLTI-AMBER observations, extracted via the standard reduction package, are significantly biased when faint targets are concerned. The visibility biases derive from a time variable…

In the near infrared where detectors are limited by read-out noise, most interferometers have been operated in wide band in order to benefit from larger photon rates. We analyze in this paper the biases caused by instrumental and turbulent…

In a few years, the second generation instruments of the Very Large Telescope Interferometer (VLTI) will routinely provide observations with 4 to 6 telescopes simultaneously. To reach their ultimate performance, they will need a fringe…

We discuss the estimation of the interferometric visibility (fringe contrast) for the exozodi survey conducted at the CHARA array with the JouFLU beam combiner. We investigate the use of the statistical median to estimate the uncalibrated…

We use a numerical simulation to investigate the effectiveness of pinhole spatial filters at optical/IR interferometers and to compare them with single-mode optical fibre spatial filters and interferometers without spatial filters. We show…

Optical phase determination is an important and established tool in diverse fields such as astronomy, biology, or quantum optics. There is increasing interest in using a lower number of total photons. However, different noise sources, such…

We describe the fringe packet tracking system used to equalise the optical path lengths at the Infrared Optical Telescope Array (IOTA) interferometer. The measurement of closure phases requires obtaining fringes on three baselines…

In a previous work, we designed a compact atom interferometer to measure homogeneous constant forces guiding the arms via shortcuts to adiabatic paths. Within this scheme we drive the atom by moving spin-dependent traps, and design a force…

The VLTI Spectro Imager project aims to perform imaging with a temporal resolution of 1 night and with a maximum angular resolution of 1 milliarcsecond, making best use of the Very Large Telescope Interferometer capabilities. To fulfill the…

It has been recently demonstrated that integrated optics could enhance accuracy, stability, and ease of use of stellar interferometry techniques. The subject of this thesis is the study of an optical component based on singlemode waveguides…

The high inertial sensitivity of atom interferometers has been used to build accelerometers and gyrometers but this sensitivity makes these interferometers very sensitive to the laboratory seismic noise. This seismic noise induces a phase…

The propagation of errors through the uniform disk visibility function is examined. Implications of those errors upon measures of absolute visibility through optical and near-infrared interferometers are considered within the context of…

Total internal reflection microscopy (TIRM) measures changes in the distance between a colloidal particle and a transparent substrate by measuring the intensity of light scattered by the particle when it is illuminated by the evanescent…