相关论文: The trigger system of the Pierre Auger Surface Det…
The surface detector array of the Pierre Auger Observatory consists of 1600 water-Cherenkov detectors, for the study of extensive air showers (EAS) generated by ultra-high-energy cosmic rays. We describe the trigger hierarchy, from the…
The aperture of the Fluorescence Detector (FD) of the Pierre Auger Observatory is evaluated from simulated events using different detector configurations: mono, stereo, 3-FD and 4-FD. The trigger efficiency has been modeled using shower…
Three months of data taken by the Engineering Array Surface Detector of the Pierre Auger Observatory have been analyzed with the aim of setting a procedure for the study of showers at E_0 ~ 10^18 eV. We present the results, concerning: (i)…
The Surface Detector of the Pierre Auger Observatory will consist of 1600 water Cherenkov tanks sampling ground particles of air showers produced by energetic cosmic rays. The arrival times are obtained from GPS and power is provided by…
The detectors of the surface array of the Pierre Auger Observatory are water Cherenkov tanks. The signals from each tank are read out using three photomultipliers. The energy of the primary particle is inferred from signal densities and…
The surface detector of the Pierre Auger Observatory is a 1600 water Cherenkov tank array on a triangular 1.5 km grid. The signals from each tank are read out using three 9'' photomultipliers and processed at a sampling frequency of 40 MHz,…
We determine the instantaneous aperture and integrated exposure of the surface detector of the Pierre Auger Observatory, taking into account the trigger efficiency as a function of the energy, arrival direction (with zenith angle lower than…
The trigger system for the Auger fluorescence telescopes is implemented in hard- and software for an efficient selection of fluorescence light tracks induced by high-energy extensive air showers. The algorithm of the third stage uses the…
We discuss the angular resolution obtained for events registered with the surface detector alone and for hybrid events, i.e., those observed simultaneously by both the surface and fluorescence detectors. The angular accuracy of the surface…
The ARGO-YBJ experiment has been designed to detect air shower events over a large size scale and with an energy threshold of a few hundreds GeV. The building blocks of the ARGO-YBJ detector are single-gap Resistive Plate Counters (RPCs).…
We describe the experimental setup and the results of RAuger, a small radio-antenna array, consisting of three fully autonomous and self-triggered radio-detection stations, installed close to the center of the Surface Detector (SD) of the…
The Pierre Auger Observatory has the capability to identify neutrino-induced extensive air showers above $10^{17}$ eV by using its large Surface Detector (SD) array. Data from the Observatory have been used to set some of the most stringent…
The Surface Detector (SD) of the Pierre Auger Observatory is a 3000 km$^2$ array of stations, whose main components are Water-Cherenkov Detectors (WCDs) recording ground-level signals from Extensive Air Showers (EASs) initiated by…
The Pierre Auger Observatory is a``hybrid'' UHECR detector. The surface detector (SD) and air fluorescence detector (FD) of the observatory are designed for observation of cosmic ray showers in coincidence, with a 10% duty cycle. The…
The Pierre Auger Observatory has the capability of detecting neutrino-induced extensive air showers by searching for very inclined showers with a significant electromagnetic component. In order to study the detector response of the surface…
The building block of the surface detector of the Pierre Auger Observatory is a water Cherenkov tank. The response to shower particles is simulated using a dedicated program based on GEANT4. To check the simulation chain, we compare the…
The reconstruction of extensive air showers (arrival direction, core position and energy estimation) by the surface detector of the Pierre Auger Observatory is discussed together with the corresponding accuracy. We determine the angular…
The Pierre Auger Observatory is a detector for ultra-high energy cosmic rays. It consists of a surface array to measure secondary particles at ground level and a fluorescence detector to measure the development of air showers in the…
The surface detector (SD) array of the southern Pierre Auger Observatory will consist of a triangular grid of 1600 water Cherenkov tanks with 1.5 km spacing. For zenith angles less than 60deg the primary energy can be estimated from the…
The Pierre Auger Observatory is designed to elucidate the origin and nature of Ultra High Energy Cosmic Rays using a hybrid detection technique. A first run of data taking with a prototype version of both detectors (the so called…