相关论文: Integration and characterization of Readout Electr…

A drift chamber readout system of the DIRAC experiment at CERN is presented. The system is intended to read out the signals from planar chambers operating in a high current mode. The sense wire signals are digitized in the 16-channel…

Single-cell prototype drift chambers were built at TRIUMF and tested with a $\sim\unit[210]{MeV/c}$ beam of positrons, muons, and pions. A cluster-counting technique is implemented which improves the ability to distinguish muons and pions…

Particle identification in gaseous detectors traditionally relies on energy loss measurements (dE/dx); however, uncertainties in total energy deposition limit its resolution. The cluster counting technique (dN/dx) offers an alternative…

IDEA (Innovative Detector for an Electron-positron Accelerator) is a general-purpose detector concept, designed to study electron-positron collisions in a wide energy range from a very large circular leptonic collider. Its drift chamber is…

Cluster counting dN/dx is a promising method to enhance particle identification for gaseous detectors, especially in next-generation collider experiments like the FCC-ee, where good pion-kaon separation over a broad momentum range is…

We describe the readout electronics for the STAR Time Projection Chamber. The system is made up of 136,608 channels of waveform digitizer, each sampling 512 time samples at 6-12 Mega-samples per second. The noise level is about 1000…

A prototype detector for Compton camera imaging is under development. A monolithic array of 19 channel Silicon drift detector with on-chip electronics is going to be used as a scatter detector for the prototype system. Custom designed…

As the Chinese Spallation Neutron Source enters Phase II, the increase in proton beam power will lead to a further boost in the intensity of pulsed neutron beams. To address the demand for higher event-rate readout electronics for…

This contribution presents a pragmatic approach to read-out electronics for drift chambers used in particle physics experiments, specifically for the R3B experiment at GSI. The design uses discrete miniature SMD components and LVDS inputs…

Designing quantum systems with the measurement speed and accuracy needed for quantum error correction using superconducting qubits requires iterative design and test informed by accurate models and characterization tools. We introduce a…

The IDEA detector concept for a future e$^{+}$e$^{-}$ collider adopts an ultra-low mass drift chamber as a central tracking system. The He-based ultra-low mass drift chamber is designed to provide efficient tracking, a high-precision…

Small-diameter Drift Tube (sMDT) detectors with 15 mm tube diameter have proven to be excellent candidates for precision muon tracking detectors in experiments at future hadron colliders like HL-LHC and FCC-hh where unprecedentedly high…

The resolution and efficiency of a precision drift-tube chamber for the ATLAS muon spectrometer with final read-out electronics was tested at the Gamma Irradiation Facility at CERN in a 100 GeV muon beam and at photon irradiation rates of…

The LHCb Outer Tracker is a straw drift detector with a modular design and a total of 53760 readout channels distributed over a sensitive area of 12 double layers of 6x5 m2 each. The main electronics readout requirement is the precise (0.5…

The performance of a wide range of quantum computing algorithms and protocols depends critically on the fidelity and speed of the employed qubit readout. Examples include gate sequences benefiting from mid-circuit, real-time,…

The skipper CCD is a special type of charge coupled device in which the readout noise can be reduced to sub-electron levels by averaging independent measurements of the same charge. Thus the charge in the pixels can be determined by…

The particle identification (PID) of hadrons plays a crucial role in particle physics experiments, especially in flavor physics and jet tagging. The cluster-counting method, which measures the number of primary ionizations in gaseous…

Quantum error mitigation (QEM) for dynamic circuits, i.e., those incorporating mid-circuit measurements and feedforward, is important for two key reasons. First, quantum error correction (QEC) circuits are instances of dynamic circuits, and…

We have developed a cryogenic platform for the control and readout of spin qubits that comprises a high density of dc and radio frequency sample interconnects based on a set of coupled printed circuit boards. The modular setup incorporates…

BaF2 (Barium fluoride) detector is one of the experiment facilities at the under construction CSNS-WNS (White Neutron Source at China Spallation Neutron Source). It is designed for precisely measuring (n,gamma) cross section with total 92…