相关论文: Integrated Switched Capacitor Array and Synchronou…
Piezoelectric Energy Harvesters (PEH) are usually used to convert mechanical energy (vibration, shocks) into electrical energy, in order to supply energy-autonomous sensor nodes in industrial, biomedical or domotic applications. Non-linear…
Piezoelectric Energy Harvesters (PEHs) are typically employed to provide additional source of energy for a sensing system. However, studies show that a PEH can be also used as a sensor to acquire information about the source of vibration by…
In the studies of piezoelectric energy harvesting (PEH) systems, literature has shown that circuit advancement has a significant effect on the enhancement of energy harvesting capability in resonance. On the other hand, some recent studies…
Bearings are critical components in industrial machinery, yet their vulnerability to faults often leads to costly breakdowns. Conventional fault detection methods depend on continuous, high-frequency vibration sensing, digitising, and…
Piezoelectric energy harvester, which generates electricity from stress or vibrations, is gaining increasing attention as a viable solution to extend battery life in wearables. Recent research further reveals that, besides generating…
This paper proposes a novel vibration energy harvesting strategy based on an extension of the Synchronous Electric Charge Extraction (SECE) approach, enabling both the maximization of the harvested power and a consequent bandwidth…
In this paper, we present a new harvesting interface, called Short Circuit Synchronous Electric Charge Extraction (SC-SECE). The SC-SECE strategy includes a tunable short-circuit time thanks to two tuning parameters, $\phi_S$ and…
Vibrational energy harvested from the bridge excitation due to the traffic flow or the wind load can be supplied to sensors in a Structural Health Monitoring (SHM) system and help prolong its service life, reduce chemical battery waste and…
This paper presents a fully integrated, self-starting shock-optimized Synchronous Electric Charge Extraction (SECE) interface for piezoelectric harvesters (PEHs). After introducing a model of the electromechanical system under shocks, we…
The goal of this research is to increase the bandwidth (BW) over which substantial energy can be harvested using a piezoelectric energy harvester (PEH). The key innovation is the use of bias-flip (BF) electronics at the output of a PEH…
Nonlinearity has enabled energy harvesting to advance towards higher power output and broader bandwidth in monostable, bistable, and multistable systems. However, challenges in operating in the high energy orbit (HEO) rather than low energy…
Energy harvesting (EH) is a multidisciplinary research area, involving physics, materials science and engineering, with the objective of providing renewable sources of sufficient power to operate targeted low-power applications.…
Piezoelectric energy harvesters (PEHs) can be used as an additional power supply for a Structural Health Monitoring (SHM) system. Its design can be optimised for the best performance; however, the optimal design depends on the input…
Vibration energy harvesting is a technology that enables electric power generation by augmenting vibrating materials or structures with piezoelectric elements. In a recent work, we quantified the intrinsic energy-harvesting availability of…
Simultaneous vibration control and energy harvesting of vehicle suspensions have attracted significant research attention over the past decades. However, existing energy harvesting shock absorbers (EHSAs) are mainly designed based on the…
Simultaneous wireless information and power transfer (SWIPT) is a promising solution for enabling long-life, and self-sustainable wireless networks. In this thesis, we propose a practical non-linear energy harvesting (EH) model and design a…
A single stage active AC/DC interface able to emulate the optimal load impedance of a Resonant Piezoelectric Vibration Energy Harvester (RPVEH) is proposed. As theoretically shown, unlike an electronic interface that emulates an optimal…
This work introduces a novel methodology to assess the performance of Piezoelectric Energy Harvesters (PEHs) in order to study auxetic enhancement possibilities. For this purpose, a new approach for evaluating the intrinsic effective…
Traditional Internet of Things (IoT) sensors rely on batteries that need to be replaced or recharged frequently which impedes their pervasive deployment. A promising alternative is to employ energy harvesters that convert the environmental…
Due to the rapid growth in demand for power for sensing devices located in remote locations, scientists' attention has been drawn to vibration energy harvesting as an alternative to batteries. As a result of over two decades of micro-scale…