相关论文: Cubic ReSTe as a High-Performance Thermoelectric M…

Ge$_{2}$Sb$_{2}$Te$_{5}$ (GST) has been widely used as a popular phase change material. In this study, we show that it exhibits high Seebeck coefficients 200 - 300 $\mu$V/K in its cubic crystalline phase ($\it{c}$-GST) at remarkably high…

Whether porosity can effectively improve thermoelectric performance is still an open question. Herein we report that thermoelectric performance can be significantly enhanced by creating porosity in n-type Mg3.225Mn0.025Sb1.5Bi0.49Te0.01,…

We study the thermoelectric properties of Te-doped FeSb2 nanostructured samples. Four samples of stoichiometry FeSb1.84Te0.16 were prepared by a hot press method at temperatures of 200, 400, 500, and 600 oC. Te-doping enhances the…

The efficiency of energy conversion in thermoelectric generators (TEGs) is directly proportional to electrical conductivity and Seebeck coefficient while inversely to thermal conductivity. The challenge is to optimize these interdependent…

Thermoelectric properties of the type-I clathrates Ba$_8$Cu$_x$Si$_{46-x}$ ($3.6 \leq x \leq 7$, $x$ = nominal Cu content) are investigated both experimentally and theoretically. The polycrystalline samples are prepared either by melting,…

SnTe, an archetypical topological crystalline insulator, often shows a transition from a highly symmetric cubic phase to a rhombohedral structure at low temperatures. In order to achieve the highly symmetric cubic phase at low temperatures…

There is evidence that magnetism can potentially increase the thermopower of materials, most likely due to magnon scattering, suggesting the incorporation of intrinsic magnetic semiconductors in non-magnetic thermoelectric materials. Here,…

In this first-principles study, we investigated the thermoelectric properties of the full-Heusler compound CsK$_2$Sb at different compressive strains. This material exhibits a valence band structure with significant effective mass…

Half-Heusler phases (space group F43m, C1b) have recently captured much attention as promising thermoelectric materials for heat-to-electric power conversion in the mid-to-high temperature range. The most studied ones are the RNiSn-type…

We present an analysis of the thermoelectric properties of of $n$-type GeTe and SnTe in relation to the lead chalcogenides PbTe and PbSe. We find that the singly degenerate conduction bands of semiconducting GeTe and SnTe are highly…

Cu$_3$SbSe$_4$ is a promising thermoelectric material due to high thermopower ($>400\ \mu$V/K) at 300K and higher. Although it has a simple crystal structure derived from zinc blende structure, previous work has shown that the physics of…

N-type Bi100-xSbx alloys have the highest thermoelectric figure of merit (zT) of all materials below 200K; here we investigate how filling multiple valence band pockets at T and H-points of the Brillouin zone produces high zT in p-type…

We show here for the first time the use of a cold sintering process (CSP) to sinter CoSb3-based thermoelectric materials. CSP at 150 {\deg}C for 90 min under a uniaxial pressure of 750 MPa yields pieces with a relative density of 86 %,…

Electronic and transport properties of CuGaTe$_2$, a hole-doped ternary copper based chalcopyrite type semiconductor, are studied using calculations within the Density Functional Theory and solving the Boltzmann transport equation within…

Searching for the high-performance thermoelectric (TE) materials has always been a long-held dream in the thermoelectricity field. Recently, it is found in experiments that the largest figure of merit ZT of $2.6$ can be reached in SnSe…

Materials with reduced dimensionality offer beneficial density-of-states (DOS) profiles for thermoelectric energy conversion, but can be impractical in realistic devices. Encouragingly, bulk high-symmetry materials can also exhibit similar…

The effects of Ir doping on the thermoelectric properties of Pt1-xIrxSb2 (x = 0, 0.01, 0.03, and 0.1) with pyrite structure were studied. Measurements of electrical resistivity rho, Seebeck coefficient S, and thermal conductivity kappa were…

Thermoelectric properties of polycrystalline p-type ZrTe5 are reported in temperature (T) range 2 - 340 K. Thermoelectric power (S) is positive and reaches up to 458 uV/K at 340 K on increasing T. The value of Fermi energy 16 meV, suggests…

SnTe is a potential thermoelectric material in the mid temperature range. Detailed techniques to enhance the figure of merit by increasing the Power Factor, and reducing thermal conductivity, of SnTe-based TE materials are discussed. The…

We report the synthesis, electronic properties, and electronic structure of ullmannite-type PtSbS, which has a cubic crystal structure without space inversion symmetry. Electrical resistivity and magnetization measured at low temperatures…