相关论文: Low-Cost Phase Precoding for Short-Reach Fiber Lin…
We consider binary continuous phase modulation (CPM) signals used in some recent low-cost and low-power consumption telecommunications standard. When these signals are generated through a low-cost transmitter, the real modulation index can…
In millimeter-wave (mmWave) MIMO systems, while a hybrid digital/analog precoding structure offers the potential to increase the achievable rate, it also faces the challenge of the need of a low-complexity design. In specific, the hybrid…
In high-dynamic range (HDR) analog-to-digital converters (ADCs), having many quantization bits minimizes quantization errors but results in high bit rates, limiting their application scope. A strategy combining modulo-folding with a low-DR…
Hybrid precoding has been recently proposed as a cost-effective transceiver solution for millimeter wave (mm-wave) systems. The analog component in such precoders, which is composed of a phase shifter network, is the key differentiating…
Massive multiple-input multiple-output (MIMO) is envisioned to offer considerable capacity improvement, but at the cost of high complexity of the hardware. In this paper, we propose a low-complexity hybrid precoding scheme to approach the…
Millimeter wave (mmWave) communications have been considered as a key technology for next generation cellular systems and Wi-Fi networks because of its advances in providing orders-of-magnitude wider bandwidth than current wireless…
Deploying periodic inline chromatic dispersion compensation enables reducing the complexity of the digital back propagation (DBP) algorithm. However, compared with nondispersion-managed (NDM) links, dispersion-managed (DM) ones suffer a…
Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention…
While fully-digital precoding achieves superior performance in massive MIMO systems, it comes with significant drawbacks in terms of computational complexity and power consumption, particularly when operating at millimeter-wave (mmWave)…
Hybrid analog-digital precoding is a key millimeter wave access technology, where an antenna array with reduced number of radio frequency (RF) chains is used with an RF precoding matrix to increase antenna gain at a reasonable cost.…
Hybrid analog/digital precoding offers a compromise between hardware complexity and system performance in millimeter wave (mmWave) systems. This type of precoding allows mmWave systems to leverage large antenna array gains that are…
Antenna arrays will be an important ingredient in millimeter wave (mmWave) cellular systems. A natural application of antenna arrays is simultaneous transmission to multiple users. Unfortunately, the hardware constraints in mmWave systems…
In this paper we propose an independent channel precoder for orthogonal frequency division multiplexing (OFDM) systems over fading channels. The design of the precoder is based on the information redistribution of the input modulated…
Precoding for multiple-input, multiple-output (MIMO) antenna systems is considered with perfect channel knowledge available at both the transmitter and the receiver. For 2 transmit antennas and QAM constellations, an approximately optimal…
Spectrally efficient communication is studied for short-reach fiber-optic links with chromatic dispersion (CD) and receivers that employ direction-detection and oversampling. Achievable rates and symbol error probabilities are computed by…
Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…
Hybrid precoding has been recently proposed as a cost-effective transceiver solution for millimeter wave (mm-wave) systems. While the number of radio frequency (RF) chains has been effectively reduced in existing works, a large number of…
This work presents techniques which can allow low-cost phased-array receivers to be reconfigured as interferometric imagers and thereby reducing cost. Since traditional phased arrays power combine incoming signals prior to digitization,…
To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…
A photonics-assisted analog wideband RF self-interference (SI) cancellation and frequency downconversion approach for in-band full-duplex (IBFD) multiple-input multiple-output (MIMO) systems with adaptive digital amplitude and delay…