相关论文: In-Circuit Characterization of Low-Frequency Stabi…
Understanding the nature of potential instabilities is indispensable for the stabilization of power amplifiers. Pole-zero identification is one of the techniques that can be used to determine the stability of a design in large-signal…
The presence of critical resonances in microwave power amplifiers has a negative impact on its behavior and performance. These critical resonances are usually predicted from pole-zero stability simulations. In this paper, a different and…
This paper proposes an efficient method for the calculation of the stabilization parameters in RF power amplifiers operating in periodic large-signal regimes. Stabilization is achieved by applying the principles of linear control theory for…
This contribution focuses on phase-noise added during frequency conversion in low-level radio frequency (LLRF) control systems. The stability of beams' parameters in linear accelerators depends on the stability of amplitude and phase of the…
Impedance measurements have been widely used with the Nyquist plot to estimate the stability of interconnected power systems. Being a black-box method for equivalent and aggregated impedance estimation, its use for the identification of…
Amplification is usually necessary when measuring the frequency instability of microwave signals. In this work, we develop a flicker noise free frequency measurement system based on a common or shared amplifier. First, we show that…
A tabletop low-noise differential amplifer with a bandwidth of 100 kHz is presented. Low voltage drifts of the order of 100 nV/day are reached by thermally stabilizing relevant amplifer components. The input leakage current is below 100 fA.…
This paper presents a research devoted to the study of instability phenomena in non-linear model with a constant brake friction coefficient. This paper outlines the stability analysis and a procedure to reduce and simplify the non-linear…
Proportional-Integral-Derivative (PID) control has been the workhorse of control technology for about a century. Yet to this day, designing and tuning PID controllers relies mostly on either tabulated rules (Ziegler-Nichols) or on classical…
A method is presented for tracing the locus of a specific peak in the frequency response under variation of a parameter. It is applicable to periodic, steady-state vibrations of harmonically forced nonlinear mechanical systems. It operates…
A low-noise amplifier (LNA) amplifies a very low-power signal without significantly degrading its signal-to-noise ratio. This paper provides the design of a linear low noise amplifier with the transistor BFP 640 using bilateral approach…
Topological phononic crystals have attracted intensive attention due to their peculiar topologically protected interface or edge states. Their operating frequency, however, is generally fixed once designed and fabricated. Here, we propose…
The resolution of low-frequency resistance noise measurements can be increased by amplitude modulation, shifting the spectrum of the resistance fluctuations away from the 1/f noise contributed by measurement instruments. However, commercial…
Background: In electrical brain signals such as Local Field Potential (LFP) and Electroencephalogram (EEG), oscillations emerge as a result of neural network activity. The oscillations extend over several frequency bands. Between their…
The high level of sidelobes in the autocorrelation function of the nonlinear frequency modulation signal is a challenge. One of the conventional methods to reduce the sidelobe levels is to use the principle of stationary phase. In this…
We describe the realization of multimode phononic correlations that arise from nonlinear interactions in a mechanical nondegenerate parametric amplifier. The nature of these correlations differs qualitatively depending on the strength of…
Absorbing airborne noise at frequencies below 300 Hz is a particularly vexing problem due to the absence of natural sound absorbing materials at these frequencies. The prevailing solution for low-frequency sound absorption is the use of…
We propose and demonstrate a system that produces squeezed vacuum using a pair of optical parametric amplifiers. This scheme allows the production of phase sidebands on the squeezed vacuum which facilitate phase locking in downstream…
This article analyzes the design of a low-noise amplifier intended as the input front-end for the measurement of the low-frequency components (below 10 Hz) of a 50 Ohm source. Low residual flicker is the main desired performance. This…
Relaxed conditions are given for stability of a feedback system consisting of an exponentially stable multi-input multi-output nonlinear plant and an integral controller. Roughly speaking, it is shown that if the composition of the plant…