相关论文: To Adopt or Not to Adopt L4S-Compatible Congestion…

The Low Latency, Low Loss, Scalable Throughput (L4S) architecture has the potential to reduce queuing delay when it is deployed at endpoints and routers throughout the Internet. However, it is not clear how TCP Prague, a prototype scalable…

On the Internet, sub-millisecond queueing delay and capacity-seeking have traditionally been considered mutually exclusive. We introduce a service that offers both: Low Latency Low Loss Scalable throughput (L4S). When tested under a wide…

The demand for ultra-low latency in modern applications, such as cloud gaming and augmented reality, has exposed the limitations of traditional congestion control algorithms regarding bufferbloat. The Low Latency, Low Loss, and Scalable…

Low Latency, Low Loss Scalable throughput (L4S) is being proposed as the new default Internet service. L4S can be considered as an `incrementally deployable clean-slate' for new Internet flow-rate control mechanisms. Because, for a brief…

In this research, we investigate the feasibility of adopting the Bottleneck Bandwidth and Round-trip propagation time (BBR) protocol as the default congestion control mechanism for TCP. Our central question is whether BBR, particularly its…

Low Latency, Low Loss, and Scalable Throughput (L4S), as an emerging router-queue management technique, has seen steady deployment in the industry. An L4S-enabled router assigns each packet to the queue based on the packet header marking.…

Motivated by recent concerns that queuing delays in the Internet are on the rise, we conduct a performance evaluation of Compound TCP (C-TCP) in two topologies: a single bottleneck and a multi-bottleneck topology, under different traffic…

The congestion control algorithm bring such importance that it avoids the network link into severe congestion and guarantees network normal operation. Since The loss based algorithms introduce high transmission delay, to design new…

BBR is a new congestion-based congestion control algorithm proposed by Google. A BBR flow sequentially measures the bottleneck bandwidth and round-trip delay of the network pipe, and uses the measured results to govern its sending behavior,…

In data centers, the nature of the composite bursty traffic along with the small bandwidth-delay product and switch buffers lead to several congestion problems that are not handled well by traditional congestion control mechanisms such as…

Although delay-based congestion control protocols such as FAST promise to deliver better performance than traditional TCP Reno, they have not yet been widely incorporated to the Internet. Several factors have contributed to their lack of…

The IETF's Prague L4S Requirements [DSBE20] expect an L4S congestion control to somehow detect if there is a classic ECN [RFB01] AQM at the bottleneck and fall back to Reno-friendly behaviour (as it would on a loss). This paper addresses…

Weaknesses in several recently proposed ideas about congestion control and avoidance in high-speed netwroks are identified. Both sides of the debate concerning prior reservation of resources versus walk-in service, open-loop control versus…

Due to the presence of buffers in the inner network nodes, each congestion event leads to buffer queueing and thus to an increasing end-to-end delay. In the case of delay sensitive applications, a large delay might not be acceptable and a…

In recent years, research efforts tried to exploit peer-to-peer (P2P) systems in order to provide Live Streaming (LS) and Video-on-Demand (VoD) services. Most of these research efforts focus on the development of distributed P2P block…

Google's BBR (Bottleneck Bandwidth and Round-trip Propagation Time) approach is used to enhance internet network transmission. It is particularly intended to efficiently handle enormous amounts of data. Traditional TCP (Transmission Control…

The choice of feedback mechanism between delay and packet loss has long been a point of contention in TCP congestion control. This has partly been resolved, as it has become increasingly evident that delay based methods are needed to…

To meet the timing requirements of interactive applications, the no-frills congestion-agnostic transport protocols like UDP are increasingly deployed side-by-side in the same network with congestion-responsive TCP. In cloud platforms, even…

Widespread use of computer networks and the use of varied technology for the interconnection of computers has made congestion a significant problem. In this report, we summarize our research on congestion avoidance. We compare the concept…

Low delay is an explicit requirement for applications such as cloud gaming and video conferencing. Delay-based congestion control can achieve the same throughput but significantly smaller delay than loss-based one and is thus ideal for…