相关论文: Analog Beamforming Codebooks for Wideband Full-Dup…
This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…
Since the spectrum below 6 GHz bands is insufficient to meet the high bandwidth requirements of 5G use cases, 5G networks expand their operation to mmWave bands. However, operation at these bands has to cope with a high penetration loss and…
The availability of large bandwidth at millimeter wave (mmWave) frequencies is one of the major factors that rendered very high frequencies a promising candidate enabler for fifth generation (5G) mobile communication networks. To confront…
Employing large antenna arrays is a key characteristic of millimeter wave (mmWave) and terahertz communication systems. However, due to the adoption of fully analog or hybrid analog/digital architectures, as well as non-ideal hardware or…
Full duplex (FD) systems suffer from very high hardware cost and high power consumption to mitigate the self-interference (SI) in the analog domain. Moreover, in millimeter wave (mmWave) they rely on hybrid beamforming (HYBF) as a signal…
Using time as an additional design parameter in electromagnetism, photonics, and wave physics is attracting considerable research interest, motivated by the possibility to explore physical phenomena and engineering opportunities beyond the…
Due to its potential to support high data rates at low latency with reasonable interference isolation, millimeter-wave (mmWave) communications has emerged as a promising solution for wireless personal-area networks (WPAN) and an enabler for…
Millimeter-wave (mmWave) cell-free massive multi-user (MU) multiple-input multiple-output (MIMO) systems combine the large bandwidths available at mmWave frequencies with the improved coverage of cell-free systems. However, to combat the…
Reconfigurable distributed antenna and reflecting surface (RDARS) is a new architecture for the sixth-generation (6G) millimeter wave (mmWave) communications. In RDARS-aided mmWave systems, the active and passive beamforming design and…
Low overhead channel estimation based on compressive sensing (CS) has been widely investigated for hybrid wideband millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems. The channel sparsifying dictionaries used in prior…
Beamforming techniques utilized either at the transmitter or the receiver terminals have achieved superior quality-of-service performances from both the multi-antenna wireless communications systems, communications intelligence and radar…
The wide bandwidths available at millimeter-wave (mmWave) frequencies have offered exciting potential to wireless communication systems and radar alike. Communication systems can offer higher rates and support more users with mmWave bands…
In order to meet the demands of `Internet above the clouds', we propose a multiple-antenna aided adaptive coding and modulation (ACM) for aeronautical communications. The proposed ACM scheme switches its coding and modulation mode according…
Multi-group multicast beamforming in wireless systems with large antenna arrays and massive audience is investigated in this paper. Multicast beamforming design is a well-known non-convex quadratically constrained quadratic programming…
Benefiting from huge bandwidth resources, millimeter-wave (mmWave) communications provide one of the most promising technologies for next-generation wireless networks. To compensate for the high pathloss of mmWave signals, large-scale…
This paper investigates a new analog beamforming architecture for massive multiple-input multiple-output (MIMO) systems, where each of the multiple transmit antennas is switched to be on or off to form a beam according to the channel state…
Millimeter-wave massive multiple-input multiple-output systems employ highly directional beamforming to overcome severe path loss, and their performance critically depends on accurate beam alignment. Conventional codebook-based methods…
Beam training of 802.11 ad is a technology that helps accelerate the analog weighting vector (AWV) selection process under the constraint of the existing code-book for AWV. However, 5G milli-meter wave (mmWave)…
Starting from first principles of wave propagation, we consider a multiple-input multiple-output (MIMO) representation of a communication system between two spatially-continuous volumes. This is the concept of holographic MIMO…
Multiuser beamforming is considered for partially-connected millimeter wave massive MIMO systems. Based on perfect channel state information (CSI), a low-complexity hybrid beamforming scheme that decouples the analog beamformer and the…