相关论文: A 0.03${mm}^2$ 100-250MHz Charge-Pump or Amplifier…

The presented paper introduces a design for a phase-locked loop (PLL) that is utilized in frequency synthesis and modulation-demodulation within communication systems and in VLSI applications. The CMOS PLL is designed using 180 nm…

This paper presents a low power, low jitter LC phase locked loop (PLL) which has been designed and fabricated in a commercial 0.25-um Silicon-on-Sapphire CMOS technology. Random jitter and deterministic jitter of the PLL are 1.3 ps and 7.5…

In this paper, we demonstrate a simple scheme of 6.835 GHz microwave frequency synthesizer based on the sub-sampling phase lock loop (PLL) technique. The application of the sub-sampling PLL is the key to simplify the architecture of the…

In current MIMO mobile communication systems, phase noise can significantly impair performance. To allow for compensation of these impairments, accurate phase noise modeling is necessary. Numerical modeling of the phase noise process at a…

This paper presents a compact, low-power, direct RF multi-phase-shift keying (PSK) transmitter (TX) that eliminates the need for a phase-locked loop (PLL) by performing phase modulation directly within a ring oscillator. The proposed…

Synchronous reference frame phase-looked loop (SRF-PLL) techniques are widely used for interfacing and control applications in the power systems and energy conversion at large. Since a PLL system synchronizes its output with an exogenous…

In a phase-locked loop (PLL) synchronized inverter, due to the strong nonlinear coupling between the PLL's parame-ters and the operation power angle, the equivalent damping coefficient will quickly deteriorate while the power angle is close…

Existing sub-/super-synchronous (SSO) suppression methods for the direct-drive permanent magnet synchronous generators (D-PMSG) integrated power systems are mainly achieved by external devices or sub-synchronous resonance damping controller…

Non-contact scanning probe microscopy (SPM) has developed into a powerful technique to image many different properties of samples. The conventional method involves monitoring the amplitude, phase or frequency of a cantilever oscillating at…

Modern applications such as energy harvesting, signal monitoring in bio-medical sensing, portable point of care devices, etc. which involve state of the art mixed signal subsystems require robust ultra low power operation. Here in this…

Clock generators are an essential and critical building block of any communication link, whether it be wired or wireless, and they are increasingly critical given the push for lower I/O power and higher bandwidth in Systems-on-Chip (SoCs)…

A clock synchronizing circuit for repeaterless low swing interconnects is presented in this paper. The circuit uses a delay locked loop (DLL) to generate multiple phases of the clock, of which the one closest to the center of the eye is…

We demonstrate a single-stage multipass cell (MPC) compressor driven directly by a 500 nJ, 5 W, 120 fs, 10 MHz oscillator that delivers efficient spectral broadening from 800 to 1200 nm with >75% transmission. The compressed pulses approach…

Symbol-level precoding (SLP) manipulates the transmitted signals to accurately exploit the multi-user interference (MUI) in the multi-user downlink. This enables that all the resultant interference contributes to correct detection, which is…

A novel design for a low dropout (LDO) voltage regulator is presented and dedicated to power many sections of a typical cellular handset. However, these baseband, RF, and audio sections have different requirements that influence which LDO…

In modern integrated circuits and wireless communication systems/devices, three key features need to be solved simultaneously to reach higher performance and more compact size: signal integrity, interference suppression, and…

A novel topology for a high gain two-stage amplifier is proposed. The proposed circuit is designed in a way that the non-dominant pole is at output of the first stage. A positive capacitive feedback (PCF) around the second stage introduces…

The upgrade of the ATLAS Liquid Argon Calorimeter readout system calls for the development of radiation tolerant, high speed and low power serializer ASIC. We have designed a phase locked loop using a commercial 0.25 um Silicon-on-Sapphire…

This article presents the development of a cost-effective and efficient electronic module for silicon photomultipliers (SiPM). The electronic module combines essential functionalities, such as a high voltage power supply, a preamplifier,…

We present a scalable in-pixel processing architecture that can reduce the data throughput by 10X and consume less than 30 mW per megapixel at the imager frontend. Unlike the state-of-the-art (SOA) analog process-in-pixel (PIP) that…