相关论文: Physical Insights into Electromagnetic Efficiency …
This study considers a point-to-point wireless link, in which both the transmitter and receiver are equipped with multiple antennas. In addition, two reconfigurable metasurfaces are deployed, one in the immediate vicinity of the transmit…
Flexible intelligent metasurface (FIM) has emerged as a transformative technology to enhance wireless sensing by dynamically morphing its three-dimensional (3D) surface shape and electromagnetic response. Unlike conventional rigid arrays,…
Reconfigurable intelligent surface (RIS) can effectively control the wavefront of the impinging signals and has emerged as a cost-effective promising solution to improve the spectrum and energy efficiency of wireless systems. Most existing…
This paper presents the design, implementation and evaluation of In-N-Out, a software-hardware solution for far-field wireless power transfer. In-N-Out can continuously charge a medical implant residing in deep tissues at near-optimal…
We experimentally demonstrate a Purcell effect-based design technique for improved impedance matching, and thus enhanced radiation efficiency from a small microwave emitter. Using an iterative process centred on comparing the phase of the…
Radio frequency (RF) wireless power transfer (WPT) is a key technology for future low-power wireless systems. However, the inherently low end-to-end power transfer efficiency (PTE) is challenging for practical applications. The main factors…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…
Recently, as explosive growth of mobile data traffic, the performance of wireless communication systems requires to be enhanced significantly in future. Intelligent reflecting surface (IRS) can be used as a promising way to improve the…
Reconfigurable Intelligent Surfaces (RISs) have emerged as a promising technology for next-generation wireless communications, offering energy-efficient control of electromagnetic (EM) waves. While conventional RIS models based on phase…
We study the problem of efficiently charging a set of rechargeable nodes using a set of wireless chargers, under safety constraints on the electromagnetic radiation incurred. In particular, we define a new charging model that greatly…
This letter describes a 40.68 MHz wireless power transfer receiver for implantable applications focused on minimizing tissue heating. The system features a novel power radiated efficiency optimization strategy and a fast-settling active…
Advancements in emerging technologies, e.g., reconfigurable intelligent surfaces and holographic MIMO (HMIMO), facilitate unprecedented manipulation of electromagnetic (EM) waves, significantly enhancing the performance of wireless…
The programmable metasurface is regarded as one of the most promising transformative technologies for next-generation wireless system applications. Due to the lack of effective perception ability of the external electromagnetic environment,…
As wireless connectivity continues to evolve towards 6G, there is an ever-increasing demand to not only deliver higher throughput, lower latency, and improved reliability, but also do so as efficiently as possible. To this point, the term…
Massive multiple-input multiple-output (MIMO) techniques have been recently advanced to tremendously improve the performance of wireless networks. However, the use of very large antenna arrays brings new issues, such as the significantly…
To reap the active and passive beamforming gain in an intelligent reflecting surface (IRS)-aided wireless network, a typical way is to first acquire the channel state information (CSI) relying on the pilot signal, and then perform the joint…
To provide multimode sensory feedback and motion control, bidirectional bionic interfaces for advanced prosthetic systems require continuous and secure energy delivery to implantable electronics and integration in the sensing WBAN (Wireless…
The design of modular, passive, and static artificial metasurfaces to be used as electromagnetic skins (EMSs) of buildings for improving the coverage in urban millimeter-wave communication scenarios is addressed. Towards this end, an ad-hoc…
In this paper, we present a discussion on the algorithms design of Electrical Impedance Tomography (EIT) for biomedical applications. Based on the Maxwell differential equations and the derived the finite element(FE) linear equations, we…
The highly energetic electrons in a transmission electron microscope (TEM) can alter or even completely destroy the structure of samples before sufficient information can be obtained. This is especially problematic in the case of zeolites,…