相关论文: Measuring the Adhesion of Graphene Flake Networks …
Two-dimensional (2D) materials are considered for numerous applications in microelectronics, although several challenges remain when integrating them into functional devices. Weak adhesion is one of them, caused by their chemical inertness.…
We study the mechanics of pressurized graphene membranes using an experimental configuration that allows the determination of the elasticity of graphene and the adhesion energy between a substrate and a graphene (or other two-dimensional…
Graphene is a very attractive material for nanomechanical devices and membrane applications. Graphene blisters based on silicon oxide micro-cavities are a simple but relevant example of nanoactuators. A drawback of this experimental set up…
Solution-processed few-layers graphene flakes, dispensed to rotating and sliding contacts via liquid dispersions, are gaining increasing attention as friction modifiers to achieve low friction and wear at technologically-relevant…
As mechanical structures enter the nanoscale regime, the influence of van der Waals forces increases. Graphene is attractive for nanomechanical systems because its Young's modulus and strength are both intrinsically high, but the mechanical…
Understanding the adhesion between graphene and other materials is crucial for achieving more reliable graphene-based applications in electronic devices and nanocomposites. The ultra-thin profile of graphene, however, poses significant…
Graphene is a promising candidate for future electronic applications. Manufacturing graphene-based electronic devices typically requires graphene transfer from its growth substrate to another desired substrate. This key step for device…
We measure the out-of-plane shear modulus of few-layer graphene (FLG) by a blister test. During the test, we employed a monolayer molybdenum disulfide (MoS2) membrane stacked onto FLG wells to facilitate the separation of FLG from the…
We report on suspended single-layer graphene deposition by a transfer-printing approach based on polydimethylsiloxane stamps. The transfer printing method allows the exfoliation of graphite flakes from a bulk graphite sample and their…
Graphene, the 2D form of carbon, has excellent mechanical, electrical and thermal properties and a variety of potential applications including NEMS, protective coatings, transparent electrodes in display devices and biological applications.…
We report a non-contact method for conductivity and sheet resistance measurements of graphene samples using a high Q microwave dielectric resonator perturbation technique, with the aim of fast and accurate measurement of microwave…
Realizing flexible strain sensor with high sensitivity and tunable gauge factor is a challenge. To meet this challenge, we report an ionic liquid gated three-dimensional graphene field effect strain sensor. The charge carrier concentration…
We have measured the mechanical properties of few-layer graphene and graphite flakes that are suspended over circular holes. The spatial profile of the flake's spring constant is measured with an atomic force microscope. The bending…
Atomically thin two-dimensional materials such as graphene exhibit extremely high-pressure sensitivity compared to the commercially used pressure sensors due to their high surface-to-volume ratio and excellent mechanical properties. The…
We report a comprehensive micro-Raman study of a pressurized suspended graphene membrane that hermetically seals a circular pit, etched in a Si/SiO$_2$ substrate. Placing the sample under a uniform pressure load results in bulging of the…
Electrostatic gating offers elegant ways to simultaneously strain and dope atomically thin membranes. Here, we report on a detailed \textit{in situ} Raman scattering study on graphene, suspended over a Si/SiO$_2$ substrate. In such a…
The controlled functionalization of graphene is critical for tuning and enhancing its properties, thereby expanding its potential applications. Covalent functionalization offers a deeper tuning of the geometric and electronic structure of…
We present a simple and fast method for thickness characterization of suspended graphene flakes that is based on transmission electron microscopy (TEM) techniques. For this method, the dynamical theory of electron diffraction (Bloch-wave…
The mechanical integrity of composite materials depends primarily on the interface strength and the defect density of the reinforcement which is the provider of enhanced strength and stiffness. In the case of graphene/ polymer…
The exceptional mechanical properties of graphene have made it attractive for nano-mechanical devices and functional composite materials. Two key aspects of graphene's mechanical behavior are its elastic and adhesive properties. These are…