相关论文: Hybrid Receiver Design for Massive MIMO-OFDM with …
In this work, we investigate dynamic oversampling techniques for large-scale multiple-antenna systems equipped with low-cost and low-power 1-bit analog-to-digital converters at the base stations. To compensate for the performance loss…
The uplink achievable rate of massive multiple- input-multiple-output (MIMO) systems, where the low-resolution analog-to-digital converters (ADCs) are assumed to equip at the base station (BS), is investigated in this paper. We assume that…
Hybrid beamforming (HB) has been widely studied for reducing the number of costly radio frequency (RF) chains in massive multiple-input multiple-output (MIMO) systems. However, previous works on HB are limited to a single user equipment…
Leveraging the available millimeter wave spectrum will be important for 5G. In this work, we investigate the performance of digital beamforming with low resolution ADCs based on link level simulations including channel estimation, MIMO…
Hybrid analog and digital beamforming transceivers are instrumental in addressing the challenge of expensive hardware and high training overheads in the next generation millimeter-wave (mm-Wave) massive MIMO (multiple-input multiple-output)…
Hybrid transceiver can strike a balance between complexity and performance of multiple-input multiple-output (MIMO) systems. In this paper, we develop a unified framework on hybrid MIMO transceiver design using matrix-monotonic…
Using multiple-input multiple-output (MIMO) with orthogonal frequency division multiplexing (OFDM) for integrated sensing and communication (ISAC) has attracted considerable attention in recent years. While most existing works focus on…
The practical deployment of massive multiple-input multiple-output (MIMO) in future fifth generation (5G) wireless communication systems is challenging due to its high hardware cost and power consumption. One promising solution to address…
Massive multiple-input multiple-output (MIMO) is promising for low earth orbit (LEO) satellite communications due to the potential in enhancing the spectral efficiency. However, the conventional fully digital precoding architectures might…
Affine Frequency Division Multiplexing (AFDM) has been proposed as an effective waveform for achieving the full diversity of doubly-dispersive (delay-Doppler) channels. While this property is closely related to range and velocity estimation…
Dual-function radar-communication (DFRC) systems, which can efficiently utilize the congested spectrum and costly hardware resources by employing one common waveform for both sensing and communication (S&C), have attracted increasing…
We investigate the information-theoretic throughout achievable on a fading communication link when the receiver is equipped with one-bit analog-to-digital converters (ADCs). The analysis is conducted for the setting where neither the…
To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
Hybrid beamforming is a promising technique to reduce the complexity and cost of massive multiple-input multiple-output (MIMO) systems while providing high data rate. However, the hybrid precoder design is a challenging task requiring…
In this paper, we consider the downlink of a massive multiple-input-multiple-output (MIMO) single user transmission system operating in the millimeter wave outdoor narrowband channel environment. We propose a novel receive spatial…
This letter considers the transceiver design in frequency division duplex (FDD) massive multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems for high-quality data transmission. We propose a novel…
Spectral efficiency is a key design issue for all wireless communication systems. Orthogonal frequency division multiplexing (OFDM) is a very well-known technique for efficient data transmission over many carriers overlapped in frequency.…
A two-stage hybrid transceiver is designed by considering a partially connected architecture at the base station (BS) for a low-resolution multi-user (MU) THz massive multiple input multiple output (MIMO) system. Due to its high bandwidth…
The future wireless communications are expected to provide new use scenarios with emerging techniques. This paper focuses on vehicle to everything (V2X) network, where vehicles should cooperatively implement information obtaining, data…