相关论文: No Analog Combiner TTD-based Hybrid Precoding for …
Massive multiple-input multiple-output (MIMO) is promising for low earth orbit (LEO) satellite communications due to the potential in enhancing the spectral efficiency. However, the conventional fully digital precoding architectures might…
In the rapidly advancing landscape of 6G, characterized by ultra-high-speed wideband transmission in millimeter-wave and terahertz bands, our paper addresses the pivotal task of enhancing physical layer security (PLS) within near-field…
Millimeter-wave (mmWave) communications plays an important role for future cellular networks because of the vast amount of spectrum available in the underutilized mmWave frequency bands. To overcome the huge free space omnidirectional path…
In this paper, we propose a novel joint hybrid precoder and combiner design for maximizing the average achievable sum-rate of single-user orthogonal frequency division multiplexing millimeter wave massive MIMO systems. We formulate the…
This study investigates simpler alternatives to coherent joint transmission for supporting robust connectivity against signal blockage in mmWave/sub-THz access networks. By taking an information-theoretic viewpoint, we demonstrate…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
Hybrid precoding is a cost-effective approach to support directional transmissions for millimeter-wave (mm-wave) communications, but its precoder design is highly complicated. In this paper, we propose a new hybrid precoder implementation,…
The power consumption of digital-to-analog converters (DACs) constitutes a significant proportion of the total power consumption in a massive multiuser multiple-input multiple-output (MU-MIMO) base station (BS). Using 1-bit DACs can…
The joint design of analog beamforming and power allocation is investigated for a single radio-frequency chain multiuser time-division multiple access system under a max-min signal-to-noise ratio (SNR) criterion. A hardware-efficient…
In this paper, the performance of indoor Terahertz (THz) communication systems with one-bit digital-to-analog converters (DACs) is investigated. Array-of-subarrays architecture is assumed for the antennas at the access points, where each RF…
Millimeter wave (mmWave) communications have been considered as a key technology for next generation cellular systems and Wi-Fi networks because of its advances in providing orders-of-magnitude wider bandwidth than current wireless…
Terahertz (THz) band communication has been widely studied to meet the future demand for ultra-high capacity. In addition, multi-input multi-output (MIMO) technique and non-orthogonal multiple access (NOMA) technique with multi-antenna also…
Multibeam technology enables the use of two or more subbeams for joint communication and radio sensing, to meet different requirements of beamwidth and pointing directions. Generating and optimizing multibeam subject to the requirements is…
This paper studies the instantaneous rate maximization and the weighted sum delay minimization problems over a K-user multicast channel, where multiple antennas are available at the transmitter as well as at all the receivers. Motivated by…
Hybrid beamforming for Terahertz (THz) ultra-massive multiple-input multiple-output (UM-MIMO) systems is a promising technology for 6G space-air-ground integrated networks, which can overcome huge propagation loss and offer unprecedented…
Millimeter-wave (mmWave) communications have been considered as a key technology for future 5G wireless networks because of the orders-of-magnitude wider bandwidth than current cellular bands. In this paper, we consider the problem of…
The deployment of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems cannot rely solely on digital precoding due to hardware constraints. Instead, hybrid precoding, which combines digital and radio frequency (RF)…
This paper proposes a hybrid dimming scheme based on joint LED selection and precoding design (TASP-HD) for multiple-user (MU) multiple-cell (MC) visible light communications (VLC) systems. In TASP-HD, both the LED selection and the…
A variety of hybrid analog-digital beamforming architectures have recently been proposed for massive multiple-input multiple-output (MIMO) systems to reduce energy consumption and the cost of implementation. In the analog processing network…
This paper presents an energy-efficient downlink precoding scheme with the objective of maximizing system energy efficiency in a multi-cell massive MIMO system. The proposed precoding design jointly considers the issues of power control,…