相关论文: Room-temperature bulk plasticity and tunable dislo…
Point defect engineering is widely used to tailor the electronic and transport properties of complex oxides, yet its influence on dislocation plasticity remains poorly understood. Here, we establish how donor (Nb) doping modifies…
The properties of quantum materials are commonly tuned using experimental variables such as pressure, magnetic field and doping. Here we explore a different approach: irreversible, plastic deformation of single crystals. We show for the…
Strain-engineering is a powerful means to tune the polar, structural, and electronic instabilities of incipient ferroelectrics. KTaO3 is near a polar instability and shows anisotropic superconductivity in electron-doped samples. Here, we…
The oxide interface between LaAlO3 and KTaO3(111) can host an electron gas that condenses into superconductivity at low temperatures. In this work, we demonstrate a local and non-volatile control of this electron gas using a biased…
Plasticity in hexagonal close packed (HCP) metals and alloys such as Titanium (Ti) and Zirconium (Zr) is carried out by the motion of $\langle a \rangle$ dislocations. Above room temperature, in situ transmission electron microscopy…
In situ straining experiments were performed in a TEM on an equimolar CoCrFeMnNi (Cantor) high entropy alloy at room and cryogenic temperature. Perfect and partial dislocation activity were recorded in both cases. Twinning directly follows…
Thermomechanical processing such as annealing is one of the main methods to tailor the mechanical properties of materials, however, much is unknown about the reorganization of dislocation structures deep inside macroscopic crystals that…
Dielectric spectroscopy of CaCu3Ti4O12 was performed spanning broad ranges of temperature (10-300K) and frequency (0.5Hz-2MHz). We attribute the permittivity step-fall to the evolution of Kirkwood-Fr\"oehlich dipole-correlations; reducing…
KTaO3 single crystals with different orientations are used as substrates for the epitaxial growth of thin films and/or as hosts for two-dimensional electron gases. Due to the polar nature of the KTaO3(001) surface, one can expect…
Dislocations are at the heart of the plastic behavior of crystalline materials yet it is notoriously difficult to perform quantitative, non-intrusive, measurements of their single or collective properties. Dislocation density is a critical…
Despite important breakthroughs in the last decade, the calculation of temperature dependent properties of solids still remains a challenging task, especially in the vicinity of structural phase transitions. We show that the combination of…
The present paper studies non-uniform plastic deformations of crystals undergoing anti-plane constrained shear. The asymptotically exact energy density of crystals containing a moderately large density of excess dislocations is found by the…
KTaO3 has recently attracted attention as a model system to study the interplay of quantum paraelectricity, spin-orbit coupling, and superconductivity. However, the high and low vapor pressures of potassium and tantalum present processing…
The local structure of high pressure BaTiO$_3$ has been interrogated by neutron total scattering methods, up to pressures of 4.18 GPa at ambient temperature. Competitive refinements of cubic, tetragonal and rhombohedral distortion modes…
Understanding crack tip - dislocation interaction is critical for improving the fracture resistance of semi-brittle materials like room-temperature plastically deformable ceramics. Here, we use a modified double cleavage drilled compression…
Accurately predicting carrier mobility in strongly anharmonic solids necessitates a precise characterization of lattice dyndamics as a function of temperature. We achieve consistency with experimental electron mobility data for bulk…
The nature of mechanically induced dislocations in SrTiO3 at low temperatures has been a disputed matter for a long time. Here we provide a systematic overview of the existing knowledge on dislocations in stoichiometric SrTiO3 complemented…
Dislocations are ubiquitous in three-dimensional solid-state materials. The interplay of such real space topology with the emergent band topology defined in reciprocal space gives rise to gapless helical modes bound to the line defects.…
The contribution to the low frequency internal friction and the thermal conductivity due to optically vibrating edge dislocation dipoles is calculated within the modified Granato-Lucke string model. The results are compared with the recent…
The mechanical properties of polycrystalline metals are governed by the interaction of defects that are generated by deformation within the 3D microstructure. In materials that deform by slip, the plasticity is usually highly heterogeneous…