相关论文: A Digital Beamforming Receiver Architecture Implem…
Multiple-input multiple-output (MIMO) radar has waveform diversity and large spatial degrees of freedom (DoFs), making it attractive for high-resolution sensing. Scaling MIMO radar to massive arrays can further improve sensing performance,…
This paper studies analog beamforming in active sensing applications, such as millimeter-wave radar or ultrasound imaging. Analog beamforming architectures employ a single RF-IF chain connected to all array elements via inexpensive phase…
Radar has become an essential sensor for autonomous navigation, especially in challenging environments where camera and LiDAR sensors fail. 4D single-chip millimeter-wave radar systems, in particular, have drawn increasing attention thanks…
Beamforming design has been widely investigated for integrated sensing and communication (ISAC) systems with full-duplex (FD) sensing and half-duplex (HD) communication. To achieve higher spectral efficiency, in this paper, we extend…
In recent years, there has been extensive research on millimeter-wave (mmWave) communication and on in-band full-duplex (FD) communication, but work on the combination of the two is relatively lacking. FD mmWave systems could offer…
A device-to-device (D2D) aided multi-antenna coded caching scheme is proposed to improve the average delivery rate and reduce the downlink (DL) beamforming complexity.} Novel beamforming and resource allocation schemes are proposed where…
As the bridge between the analog world and digital computers, analog-to-digital converters are generally used in modern information systems such as radar, surveillance, and communications. For the configuration of analog-to-digital…
In this paper, we propose and evaluate a novel beamforming strategy for directional frame timing synchronization in wideband millimeter-wave (mmWave) systems operating with low-resolution analog-to-digital converters (ADCs). In the employed…
This paper considers hybrid beamforming (HB) for downlink multiuser massive multiple input multiple output (MIMO) systems with frequency selective channels. For this system, first we determine the required number of radio frequency (RF)…
Advances in astronomy are intimately linked to advances in digital signal processing (DSP). This special issue is focused upon advances in DSP within radio astronomy. The trend within that community is to use off-the-shelf digital hardware…
Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…
Millimeter wave (mmWave) spectrum has drawn attention due to its tremendous available bandwidth. The high propagation losses in the mmWave bands necessitate beamforming with a large number of antennas. Traditionally each antenna is paired…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
One way to reduce the power consumption in large-scale multiple-input multiple-output (MIMO) systems is to employ low-resolution analog-to-digital converters (ADCs). In this paper, we investigate antenna selection for large-scale MIMO…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
In this paper, we investigate hybrid analog/digital beamforming for multiple-input multiple-output (MIMO) systems with low-resolution analog-to-digital converters (ADCs) for millimeter wave (mmWave) communications. In the receiver, we…
Large-scale multiple-antenna systems with large bandwidth are fundamental for future wireless communications, where the base station employs a large antenna array. In this scenario, one problem faced is the large energy consumption as the…
This paper studies power-efficient uplink transmission design for federated learning (FL) that employs over-the-air analog aggregation and multi-antenna beamforming at the server. We jointly optimize device transmit weights and receive…
Recent generations of Field Programmable Gate Arrays (FPGAs) have become indispensible tools for complex state machine control and signal processing, and now routinely incorporate CPU cores to allow execution of user software code. At the…