相关论文: There Are Two Distinct Photon Gases Present Inside…
In conventional solar cell semiconductor materials (predominantly Si) photons with energy higher than the band gap initially generate hot electrons and holes, which subsequently cool down to the band edge by phonon emission. Due to the…
We calculate the maximal absorption enhancement obtainable by guided mode excitation in a weakly absorbing dielectric slab over wide wavelength ranges. The slab mimics thin film silicon solar cells in the low absorption regime. We consider…
We propose a new scintillation-type detector in which high-energy radiation produces electron-hole pairs in a direct-gap semiconductor material that subsequently recombine producing infrared light to be registered by a photo-detector. The…
The Shockley-Queisser (SQ) limit, introduced by W. Shockley and H. J. Queisser in 1961, is the most well-established fundamental efficiency limit for single-junction photovoltaic solar cells. For widely-studied semiconductors such as Si,…
Thin-film solar cells with CuIn$_x$Ga$_{1-x}$Se$_2$ (CIGS) absorber are still far below their efficiency limit, although lab cells reach already 19.9%. One important aspect is the homogeneity of the alloy. Large-scale simulations combining…
Luminescent coupling is a characteristic of multi-junction solar cells which has often been neglected in models of their performance. The effect describes the absorption of light emitted from a higher band gap semiconductor by a lower band…
Thin-film solar cells that are considered as the second generation of solar cells are known for their low cost and acceptable efficiency. In this technology, semiconductor layers with a thickness of micrometer are deposited on thick enough…
Solar photons possessing energy less than the band-gap of a single-junction solar cell can be utilized via the up-conversion (UC) of two or more photons, resulting in the emission of a single above-bandgap photon. Due to the non-linear…
We introduce a limit for the strength of coupling light into the modes of solar cells. This limit depends on both a cell's thickness and its modal properties. For a cell with refractive index n and thickness d, we obtain a maximal coupling…
The Shockley-Queisser limit is one of the most fundamental results in the field of photovoltaics. Based on the principle of detailed balance, it defines an upper limit for a single junction solar cell that uses an absorber material with a…
The Shockley-Queisser limit describes the maximum solar energy conversion efficiency achievable for a particular material and is the standard by which new photovoltaic technologies are compared. This limit is based on the principle of…
Maximum efficiency of ideal single-junction photovoltaic (PV) cells is limited to 33% (for one sun illumination) by intrinsic losses such as band edge thermalization, radiative recombination, and inability to absorb below-bandgap photons.…
A new strategy for eliminating photocurrent losses due to the metal contacts on the front of a solar cell was proposed, simulated, and tested. By placing triangular cross-section lines of low refractive index on top of the contacts,…
A high photon to electricity conversion efficiency of 47.2082% was achieved by a novel combination of In0.51Ga0.49P, GaAs, In0.24Ga0.76As and In0.19Ga0.81Sb subcell layers in a quadruple junction solar cell design. The electronic bandgap of…
Theoretically and experimentally we have proved the existence of optimal thickness of the porous layer used as an anti-reflection coating in solar cells. We have taken into account the joint mechanisms of generation and recombination of…
Gas convection is observed in the solar photosphere as the granulation, i.e., having highly time-dependent cellular patterns, consisting of numerous bright cells called granules and dark surrounding-channels called intergranular lanes. Many…
Nano-scaled metallic or dielectric structures may provide various ways to trap light into thin-film solar cells for improving the conversion efficiency. In most schemes, the textured active layers are involved into light trapping structures…
Solar energy is rapidly becoming a robust renewable energy source to conventional finite resources such as fossil fuels. It is harvested using interconnected photovoltaic panels, typically built with crystalline silicon cells, i.e.…
The challenge in solar energy today is not the cost of photovoltaic (PV) electricity generation, already competing with fossil fuel prices, but rather utility-scale energy storage and flexibility in supply. Low-cost thermal energy storage…
Organic-inorganic halide perovskite solar cells have enormous potential to impact the existing photovoltaic industry. As realizing a higher conversion efficiency of the solar cell is still the most crucial task, a great number of schemes…