相关论文: Modeling Fault Recovery and Transient Stability of…

A model predictive control (MPC) method for enhancing post-fault transient stability of a grid-forming (GFM) inverter based resources (IBRs) is developed in this paper. This proposed controller is activated as soon as the converter enters…

Grid-forming (GFM) inverter-based resources (IBRs) are capable of emulating the external characteristics of synchronous generators (SGs) through the careful design of the control loops. However, the current limiter in the control loops of…

Due to the energy crisis and environmental pollution, the installed capacity of inverter-based resources (IBRs) in power grids is rapidly increasing, and grid-following control (GFL) is the most prevalent at present. Meanwhile, grid-forming…

During grid faults, grid-forming converters are typically suggested to switch from a voltage-source to a current-source mode to limit the current and protect the electronics. This transition has the potential for the converter to…

Differing from synchronous generators (SGs), grid-forming inverter-based resources (GFM-IBRs) exhibit rapid variations in their output impedances during transmission line faults due to the overcurrent limitation. As a result, the source…

Modern power systems increasingly demand converter-driven generation systems that integrate seamlessly with grid infrastructure. Grid-based converters are particularly advantageous, as they operate in harmony with conventional synchronous…

Inverter-based resources (IBRs) are a key component in the ongoing modernization of power systems, with grid-forming (GFM) inverters playing a central role. Effective fault current limiting is a major challenge to modernizing power systems…

Grid-forming (GFM) inverters can significantly alter the fault characteristics of power systems, which challenges the proper function of protective relays. This paper gives a holistic analysis of the interaction between GFM inverter-based…

Grid-connected inverters are required to operate stably under a wide range of grid conditions. However, conventional grid-following (GFL) control may suffer from instability under weak-grid conditions, while grid-forming (GFM) control may…

Grid forming control applied to power converters that interface storage or renewable generation to the power grid, has been identified as a potential solution to facilitate a substantial share of converter-based renewable generation in the…

This work develops a constraint-aware grid-forming (GFM) control that explicitly accounts for current limits and modulation limits within the GFM oscillator dynamics generating the GFM voltage reference (i.e., phase angle and magnitude).…

This paper investigates how grid-forming (GFM) and grid-following (GFL) control strategies in inverter-based resources (IBRs) influence line distance and differential protection in converter-dominated transmission systems. A modified IEEE…

This article introduces two control frameworks: one for Grid-Following (GFL) inverters aiding Grid-Forming (GFM) inverters in voltage regulation during large contingency events and optimizing power transactions under normal conditions; and…

Under asymmetrical faults, analyzing the transient stability of grid-forming voltage-source converters (GFM-VSCs) becomes essential because their behavior fundamentally differs from that under symmetrical faults. When current limiting is…

Inverter-based resources (IBRs) are becoming increasingly prevalent in power systems. Due to the inherently low inertia of inverters, there is a heightened risk of disruptive voltage oscillations. A particular challenge in the operation of…

The increasing penetration of inverter-based resources (IBRs) has fundamentally altered the transient stability characteristics of modern power systems. IBRs typically rely on proportional--integral (PI) controllers for synchronization and…

In traditional views, the build-up of accelerating energy during faults can cause the well-known first-swing angle instability in synchronous generators (SGs). Interestingly, this letter presents a new insight that the accumulation of…

This paper employs modal analysis to study the core inertial dynamics of governor-controlled synchronous generators (GC-SG), droop-based grid-forming (GFM) converters, and their most fundamental interactions. The results indicate that even…

This paper focuses on the challenging task of bottom-up restoration in a complete blackout system using Grid-forming (GFM) converters. Challenges arise due to the limited current capability of power converters, resulting in distinct dynamic…

In this paper we consider a possibility of stabilizing very fast electromagnetic interactions between Inverter Based Resources (IBRs), known as the Control Induced System Stability problems. We propose that when these oscillatory…