相关论文: Characterization of Visible Range Gain in Praseody…
Taking advantages of ultra-narrow bandwidth and high noise rejection performance of the Faraday anomalous dispersion optical filter (FADOF), simultaneously with the coherent amplification of atomic stimulated emission, a stimulated…
An analytically expression for the temperature dependence of the signal gain of an erbium-doped fiber amplifier (EDFA) pumped at 1480 \textit{nm} are theoretically obtained by solving the propagation equations with the amplified spontaneous…
We have characterized a semiconductor amplifier laser system which provides up to 200mW output after a single-mode optical fiber at 780nm wavelength. The system is based on a tapered semiconductor gain element, which amplifies the output of…
We demonstrated all-fiber amplification of 11 ps pulses from a gain-switched laser diode at 1064 nm. The diode was driven at a repetition rate of 40 MHz and delivered 13 $\mu$W of fiber-coupled average output power. For the low output pulse…
Multimode fibers have been proposed for mitigating nonlinear effects in high-power fiber amplifiers, allowing for significant power scaling. Most previous studies on light propagation in continuous-wave fiber amplifiers focus on single mode…
We report on the design and numerical simulation of a tunable, near-infrared (NIR) femtosecond noncollinear optical parametric amplifier (OPA) seeded by a nonlinear fiber amplifier operating in the parabolic and gain-managed regime. With…
Optical parametric amplifiers (OPAs) are promising to overcome the wavelength coverage and noise limitations in conventional optical amplifiers based on rare-earth doping and semiconductor gain. However, the high power requirement remains a…
Here, we demonstrate all-fiber direct amplification of 11 picosecond pulses from a gain-switched laser diode at 1063nm. The diode was driven at a repetition rate of 40MHz and delivered 13$\mu$W of fiber-coupled average output power. For the…
The dependence of the relative population inversion in Er3+-doped fiber amplifiers (EDFAs) upon temperature and cross sections, taking into account the amplified spontaneous emission (ASE), are investigated theoretically by the modified…
We describe a fiber Raman amplifier for nanosecond and sub-nanosecond pulses centered around 1260 nm. The amplification takes place inside a 4.5-m-long polarization-maintaining phosphorus-doped fiber, pumped at 1080 nm by 3-ns-long pulses…
A comparative study of the gain achievement is performed in a waveguide optical amplifier whose active layer is constituted by a silica matrix containing silicon nanograins acting as sensitizer of either neodymium ions (Nd 3+) or erbium…
We report design and subsequent fabrication of an intrinsically gain flattened Erbium doped fiber amplifier (EDFA) based on a highly asymmetrical and concentric dual-core fiber, inner core of which was only partially doped. Phase-resonant…
A model of an Er$^{3+}$/Yb$^{3+}$ co-doped glass gain medium is considered. The system of rate equations taking into account a minimum set of processes required to describe experimental data is built. As a result, a moderate number of…
The efficient and independent operation of power-over-fiber (PoF) and distributed acoustic sensing (DAS) has been demonstrated using standard single-mode fiber (SSMF). A transmission optical power efficiency (OPTE) of 6.67% was achieved…
A particularly simple setup is introduced to study the influence of time-delayed coherent feedback on the optical squeezing properties of the degenerate parametric amplifier (DPA). The possibility for significantly enhanced squeezing is…
Circuit QED based quantum information processing relies on low noise amplification for signal readout. In the realm of microwave superconducting circuits, this amplification is often achieved via Josephson parametric amplifiers (JPA). In…
Phase sensitive amplifiers (PSA), contrary to usual phase insensitive amplifiers (PIA), are in principle capable to achieve noiseless amplification, i.e. exhibit a quantum-limited noise figure (NF) of 0 dB. When implemented using four-wave…
Recent experimental results have reported the observation of beam self-cleaning or, more generally, nonlinear beam reshaping in active multimode fibers. In this work we present a numerical analysis of these processes, by considering the…
This study presents the development of two graphical interfaces using Matlab's graphical user interface tool, GUIDE, to model the steady-state and dynamic responses of Erbium (Er$^{3+}$)-doped fiber amplifiers. The primary focus is on their…
Doping cadmium oxide with rare earth (RE) elements is a way to control the band gap and enhance carrier concentration and mobility. This work presents how one of REs, europium, impacts performance of CdO/Si diode. The samples were grown…