相关论文: Design of A Single Antenna With Tunable In-Band RC…

Radar cross section (RCS) reduction has become one of the critical research areas in recent years. The RCS of the target should be small to avoid detection. Different methods are used to reduce RCS, but the major challenge with many RCS…

This paper presents a slot antenna array with a reconfigurable radar cross section (RCS). The antenna system is formed by combining a liquid absorber with a 2*2 slot antenna array. The liquid absorber consists of a polymethyl methacrylate…

Controlling the in-band co-polarization scattering of the antenna while maintaining its radiation performance is crucial for the low observable platform. Thus, this paper studies the in-band co-polarization scattering beam scanning of…

This paper presents an investigation on the Radar Cross-Section (RCS) of various targets, with the objective of analysing how RCS properties vary with frequency. Targets such as an Automated Guided Vehicle (AGV), a pedestrian, and a…

Reverberation chambers (RCs) were recently reported as a low-cost alternative to anechoic chambers (ACs) to perform radar cross-section (RCS) pattern measurements. The method consists of using transmitting and receiving antennas pointing…

In this study, we perform a statistical analysis of the radar cross section (RCS) for various test targets in an indoor factory at \(25\)-\(28\) GHz, with the goal of formulating parameters that may be used for target identification and…

It is shown that a receiver equipped with two antennas may null an arbitrary large number of spatial directions to any desired accuracy, while maintaining the interference-free signal-to-noise ratio, by judiciously adjusting the distance…

In this work, we propose a technique to enhance the performance of circular patch antennas using an embedded system of cylindrical impedance surfaces. The technique utilizes a derived analytical model of a circular patch antenna containing…

Impedance tuning has shown promise to maximize output power, gain, or efficiency for transmitter amplifier devices in changing frequency or array environments. Using impedance tuning in phased-array elements, however, has a significant and…

This paper presents the design and implementation of a simple, single-layer, broadband (97%, 11.3-32.3 GHz) Radar Cross Section Reduction (RCSR) Modulated Surface (MS). It uses modulation of the edge-length of the square patch (SP)…

A study of channel hardening in a large-scale antenna system has been carried out by means of indoor channel measurements over four frequency bands, namely 1.472 GHz, 2.6 GHz, 3.82 GHz and 4.16 GHz. NTNU's Reconfigurable Radio Network…

In this paper, a low-cost, simple and reliable bi-static Radar Cross Section (RCS) measurement method making use a historic Marconi set-up is presented. It uses a transmitting (Tx) antenna (located at a constant position, at a reference…

We propose to use channel inversion power control (CIPC) to achieve one-way ultra-reliable and low-latency communications (URLLC), where only the transmission in one direction requires ultra reliability and low latency. Based on channel…

Accurate radar cross section (RCS) modeling is crucial for characterizing target scattering and improving the precision of Integrated Sensing and Communication (ISAC) channel modeling. Existing RCS models are typically designed for specific…

In this paper, we investigate a novel reconfigurable distributed antennas and reflecting surface (RDARS) aided multi-user massive MIMO system with imperfect CSI and propose a practical two-timescale (TTS) transceiver design to reduce the…

A novel miniaturized printed folded dipole antenna has been designed for narrowband sensing applications. It is shown that the antenna may be systematically engineered to achieve matching to a practical source impedance at frequencies well…

Significant radar range degradation can be incurred due to variations in antenna impedance from changing array scan angle. Element-wise reconfigurable impedance tuners can be used to optimally match the power amplifier device; however, the…

Adaptive impedance matching between antennas and radio frequency front-end modules is critical for maximizing power transmission efficiency in mobile communication systems. Conventional numerical and analytical methods struggle with a…

We propose a novel coded integrated passive sensing and communication (CIPSAC) system with orthogonal frequency division multiplexing (OFDM), where a multi-antenna base station (BS) passively senses the parameters of the targets and decodes…

Full-duplex (FD) is an attractive technology that can significantly boost the throughput of wireless communications. However, it is limited by the severe self-interference (SI) from the transmitter to the local receiver. In this paper, we…