相关论文: Two-timescale joint power control and beamforming …

Multiuser beamforming is considered for partially-connected millimeter wave massive MIMO systems. Based on perfect channel state information (CSI), a low-complexity hybrid beamforming scheme that decouples the analog beamformer and the…

Reconfigurable intelligent surface (RIS) can be employed in a cell-free system to create favorable propagation conditions from base stations (BSs) to users via configurable elements. However, prior works on RIS-aided cell-free system…

In this paper, we study power allocation for secure communication in a multiuser multiple-input single-output (MISO) downlink system with simultaneous wireless information and power transfer. The receivers are able to harvest energy from…

In this paper, linear beamforming design for amplify-and-forward relaying cellular networks is considered, in which base station, relay station and mobile terminals are all equipped with multiple antennas. The design is based on minimum…

Large-scale distributed antenna systems with many access points (APs) that serve the users by coherent joint transmission is being considered for 5G-and-beyond networks. The technology is called Cell-free Massive MIMO and can provide a more…

Large multiple-input multiple-output (MIMO) networks promise high energy efficiency, i.e., much less power is required to achieve the same capacity compared to the conventional MIMO networks if perfect channel state information (CSI) is…

This paper investigates a six-dimensional movable antenna (6DMA)-aided cell-free multi-user multiple-input multiple-output (MIMO) communication system. In this system, each distributed access point (AP) can flexibly adjust its array…

In this paper we explore the use of full-duplex radio to improve the spectrum efficiency in a two-way relay channel where two sources exchange information through an multi-antenna relay, and all nodes work in the full-duplex mode. The…

This paper considers pilot design to mitigate pilot contamination and provide good service for everyone in multi-cell Massive multiple input multiple output (MIMO) systems. Instead of modeling the pilot design as a combinatorial assignment…

The design of a set of beamformers for the multiuser multiple-input single-output (MISO) downlink that provides the receivers with prespecified levels of quality-of-service (QoS) can be quite challenging when the channel state information…

This paper investigates the performance of a two-timescale transmission design for uplink reconfigurable intelligent surface (RIS)-aided cell-free massive multiple-input multiple-output (CF-mMIMO) systems. We consider the Rician channel…

Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…

A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…

This paper considers the optimum single cell power-control maximizing the aggregate (uplink) communication rate of the cell when there are peak power constraints at mobile users, and a low-complexity data decoder (without successive…

We study physical layer multicasting in multicell networks where each base station, equipped with multiple antennas, transmits a common message using a single beamformer to multiple users in the same cell. We investigate two coordinated…

This paper considers a cell-free massive MIMO (CF-mMIMO) system using conjugate beamforming (CB) with fractional-exponent normalization. Assuming independent Rayleigh fading channels, a generalized closed-form expression for the achievable…

Future multi-input multi-output (MIMO) wireless communications systems will use beamforming as a first-step towards realizing the capacity requirements necessitated by the exponential increase in data demands. The focus of this work is on…

Massive multi-input multi-output (MIMO) uses a very large number of low-power transmit antennas to serve much smaller numbers of users. The most widely proposed type of massive MIMO transmit beamforming is zero-forcing, which is based on…

Recently, the so-called cell-free Massive MIMO architecture has been introduced, wherein a very large number of distributed access points (APs) simultaneously and jointly serve a much smaller number of mobile stations (MSs). A variant of…

This paper investigates a multi-input single-output (MISO) wireless powered communication network (WPCN) under the protocol of harvest-then-transmit. The power station (PS) with reliable power supply can replenish the passive user nodes by…