相关论文: Efficacy Analysis of Power Swing Blocking and Out-…

This paper investigates power swing characteristics of grid-forming voltage source converter (GFM-VSC) systems considering the current limitation mode in both non-inertial and inertial GFM-VSC systems. Following grid faults, non-inertial…

Transients of a grid-synchronized voltage source converter (VSC) are closely related to over- currents and voltages occurred under large disturbances (e.g. a grid fault). Previous analysis in evaluating these transients usually neglect the…

Differing from synchronous generators, there are lack of physical laws governing the synchronization dynamics of voltage-source converters (VSCs). The widely used phase-locked loop (PLL) plays a critical role in maintaining the synchronism…

Integrating grid-forming converters (GFMCs) into grid-following converter (GFLC)-dominated power systems enhances the grid strength, but GFMCs' current-limiting characteristic triggers dynamic switching between constant voltage control…

The renewable energy is connected to the power grid through power electronic converters, which are lack of make the inertia of synchronous generator/machine (SM) be lost. The increasing penetration of renewable energy in power system…

Grid-forming (GFM) inverter-based resources (IBRs) can emulate the external characteristics of synchronous generators (SGs) through appropriate control loop design. However, in systems with GFM IBRs, the apparent impedance trajectory under…

Low-frequency oscillations (LFOs) present a significant challenge to the stability and reliability of power systems, especially in grids with a high penetration of renewable energy sources. Traditional grid-following (GFL) inverters have…

In scenarios where synchronous generators (SGs) and grid-following renewable energy sources (GFLR) are co-located, existing research, which mainly focuses on the first-swing stability of SGs, often overlooks ongoing dynamic interactions…

Fluctuations in phase angle and frequency under large disturbances can lead to loss of synchronism (LOS) in grid-following (GFL) converters. The power angle and frequency of synchronous generators (SGs) correspond to rotor position and…

Under asymmetrical faults, analyzing the transient stability of grid-forming voltage-source converters (GFM-VSCs) becomes essential because their behavior fundamentally differs from that under symmetrical faults. When current limiting is…

The MMC-HVDC connected offshore wind farms (OWFs) could suffer short circuit fault (SCF), whereas their transient stability is not well analysed. In this paper, the mechanism of the loss of synchronization (LOS) of this system is analysed…

The oscillation phenomena associated with the control of voltage source converters (VSCs) are widely concerning, and locating the source of these oscillations is crucial to suppressing them; therefore, this paper presents a locating scheme,…

The power synchronization control (PSC) has been increasingly used with voltage-source converters (VSCs) connected to the weak ac grid. This paper presents an in-depth analysis on the transient stability of the PSC-VSC by means of the phase…

We consider a grid-connected voltage source converter (VSC) and address the problem of estimating the grid angle and frequency, information that is essential for an appropriate operation of the converter. We design phase-locked loop (PLL)…

This letter presents a comprehensive analysis of the stability phenomenon related to the ability of generators to remain in synchronism when subjected to small or large disturbances, in power systems with both synchronous machines and…

This paper presents a novel strategy for the synchronization of grid-following Voltage Source Converters (VSCs) in power systems with low rotational inertia. The proposed synchronization unit is based on emulating the physical properties of…

Phase-locked loops (PLL), Costas loops and other synchronizing circuits are featured by the presence of a nonlinear phase detector, described by a periodic nonlinearity. In general, nonlinearities can cause complex behavior of the system…

Grid-forming voltage source converters (GFM-VSCs) play a crucial role in the stability of power systems with large amounts of converter-based generation. Transient stability (angle stability under large disturbances) is a critical limiting…

The converter control functions to provide the capabilities similar to synchronous generators are referred to as grid forming converters (GFC). Identical to a synchronous machine, a grid forming converter is expected to behave as a voltage…

Power dissipation in sequential circuits is due to increased toggling count of Circuit under Test, which depends upon test vectors applied. If successive test vectors sequences have more toggling nature then it is sure that toggling rate of…