相关论文: Low-Power Wake-Up Signal Design in 3GPP Release 18

The Low-Power Wake-Up Signal (LP-WUS) and Low-Power Synchronization Signal (LP-SS), introduced in 3GPP 5G-Advanced Release 19, mark an important advancement toward power-efficient IoT communications. This paper provides a comprehensive…

Enhancing the energy efficiency of devices stands as one of the key requirements in the fifth-generation (5G) cellular network and its evolutions toward the next generation wireless technology. Specifically, for battery-limited…

This paper presents a comprehensive study on low-complexity waveform, modulation and coding (WMC) designs for the 3rd Generation Partnership Project (3GPP) Ambient Internet of Things (A-IoT). A-IoT is a low-cost, low-power IoT system…

New radio (NR) positioning in the Third Generation Partnership Project (3GPP) Release 18 (Rel-18) enables 5G-advanced networks to achieve ultra-high accuracy positioning without dependence on global navigation satellite systems (GNSS) with…

5G-Advanced and likely 6G will support a new low-power wake-up signal (LP-WUS) enabling low-power devices, equipped with a complementary ultra low-power receiver to monitor wireless traffic, to completely switch off their main radio. This…

The peak-to-average-power ratio (PAPR) of the frequency domain multiplexed wake-up signals (WUSs) specified in IEEE P802.11ba can be very large and difficult to manage since it depends on the number and allocation of the active channels,…

Low peak-to-average-power ratio (PAPR) transmissions significantly improve the cell coverage as they enable high power transmissions without saturating the power amplifier. A new modulation scheme, namely, pi/2-BPSK was introduced in the…

Reducing energy consumption is a pressing issue in low-power machine-type communication (MTC) networks. In this regard, the Wake-up Signal (WuS) technology, which aims to minimize the energy consumed by the radio interface of the…

The 3rd Generation Partnership Project (3GPP) is currently studying machine learning (ML) for the fifth generation (5G)-Advanced New Radio (NR) air interface, where spatial and temporal-domain beam prediction are important use cases. With…

For the fifth generation (5G) wireless network technology, the most important design goals were improved metrics of reliability and latency, in addition to network resilience and flexibility so as to best adapt the network operation for new…

We present in this paper an ultra-low power (ULP) Recurrent Neural Network (RNN) based classifier for an always-on voice Wake-Up Sensor (WUS) with performances suitable for real-world applications. The purpose of our sensor is to bring down…

In this paper, we design a simple, low-cost, and low-power wake-up receiver which can be used for an IEEE 802.11-compliant device to remotely wake up the other devices by utilizing its own wireless LAN (WLAN) signals. The employed wake-up…

The 3-level pulse amplitude modulation (PAM-3) signaling is expected to be widely used in memory interfaces for its greater voltage margins compared to PAM-4. To maximize the benefit of PAM-3, we propose three low-power data encoding…

The fifth generation (5G) of wireless systems holds the promise of supporting a wide range of services with different communication requirements. Ultra-reliable low-latency communications (URLLC) is a generic service that enables…

In this work, the design of robust, protograph-based low-density parity-check (LDPC) codes for rate-adaptive communication via probabilistic shaping is considered. Recently, probabilistic amplitude shaping (PAS) by B\"ocherer et al. has…

This work investigates protograph-based LDPC codes for the AWGN channel with OOK modulation. A non-uniform distribution of the OOK modulation symbols is considered to improve the power efficiency especially for low SNRs. To this end, a…

Since the introduction of fifth-generation new radio (5G-NR) in Third Generation Partnership Project (3GPP) Release 15, swift progress has been made to evolve 5G with 3GPP Release 18 emerging. A critical aspect is the design of massive…

A customary solution to reduce the energy consumption of wireless communication devices is to periodically put the radio into low-power sleep mode. A relevant problem is to schedule the wake-up of nodes in such a way as to ensure proper…

In this paper, we propose downlink signal design and optimal uplink scheduling for the wireless powered communication networks (WPCNs). Prior works give attention to resource allocation in a static channel because users are equipped with…

The fifth generation (5G) wireless technology is primarily developed to support three classes of use cases, namely, enhanced mobile broadband (eMBB), ultra-reliable and low-latency communication (URLLC), and massive machine-type…