相关论文: Deep Learning Based Uplink Multi-User SIMO Beamfor…

Existing beamforming-based full-duplex solutions for multi-antenna wireless systems often rely on explicit estimation of the self-interference channel. The pilot overhead of such estimation, however, can be prohibitively high in…

This study considers a novel full-duplex (FD) massive multiple-input multiple-output (mMIMO) system using hybrid beamforming (HBF) architecture, which allows for simultaneous uplink (UL) and downlink (DL) transmission over the same…

Massive multiuser multiple-input multiple-output (MU-MIMO) has been the mainstream technology in fifth-generation wireless systems. To reduce high hardware costs and power consumption in massive MU-MIMO, low-resolution digital-to-analog…

Downlink beamforming is a key technology for cellular networks. However, computing the transmit beamformer that maximizes the weighted sum rate subject to a power constraint is an NP-hard problem. As a result, iterative algorithms that…

The stringent performance requirements of future wireless networks, such as ultra-high data rates, extremely high reliability and low latency, are spurring worldwide studies on defining the next-generation multiple-input multiple-output…

Robust beamforming design under imperfect channel state information (CSI) is a fundamental challenge in multiuser multiple-input multiple-output (MU-MIMO) systems, particularly when the channel estimation error statistics are unknown.…

Cell-free massive MIMO (CF-mMIMO) systems represent a promising approach to increase the spectral efficiency of wireless communication systems. However, near-optimal beamforming solutions require a large amount of signaling exchange between…

Hybrid beamforming is widely recognized as an important technique for millimeter wave (mmWave) multiple input multiple output (MIMO) systems. Generalized spatial modulation (GSM) is further introduced to improve the spectrum efficiency.…

Supporting high mobility in millimeter wave (mmWave) systems enables a wide range of important applications such as vehicular communications and wireless virtual/augmented reality. Realizing this in practice, though, requires overcoming…

Cell-free network is considered as a promising architecture for satisfying more demands of future wireless networks, where distributed access points coordinate with an edge cloud processor to jointly provide service to a smaller number of…

We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…

Reconfigurable Intelligent Surfaces (RISs) are one of the key emerging 6th Generation (6G) technologies that are expected to improve the link budgets between transmitters and receivers by adding artificial propagation paths. In such…

Cell-free Massive MIMO (multiple-input multiple-output) refers to a distributed Massive MIMO system where all the access points (APs) cooperate to coherently serve all the user equipments (UEs), suppress inter-cell interference and mitigate…

Compressed sensing (CS)-based techniques have been widely applied in the grant-free non-orthogonal multiple access (NOMA) to a single-antenna base station (BS). In this paper, we consider the multi-antenna reception at the BS for uplink…

Massive spatial modulation aided multiple-input multiple-output (SM-MIMO) systems have recently been proposed as a novel combination of spatial modulation (SM) and of conventional massive MIMO, where the base station (BS) is equipped with a…

In this paper, randomly-directional beamforming (RDB) is considered for millimeter-wave (mmwave) multi-user (MU) multiple-input single-output (MISO) downlink systems. By using asymptotic techniques, the performance of RDB and the MU gain in…

Federated learning (FL) is recognized as a key enabling technology to support distributed artificial intelligence (AI) services in future 6G. By supporting decentralized data training and collaborative model training among devices, FL…

In this paper, linear beamforming design for amplify-and-forward relaying cellular networks is considered, in which base station, relay station and mobile terminals are all equipped with multiple antennas. The design is based on minimum…

In massive multiple-input multiple-output (MIMO) systems, hybrid analog-digital (AD) beamforming can be used to attain a high directional gain without requiring a dedicated radio frequency (RF) chain for each antenna element, which…

Machine learning algorithms have recently been considered for many tasks in the field of wireless communications. Previously, we have proposed the use of a deep fully convolutional neural network (CNN) for receiver processing and shown it…