相关论文: Theory of Transverse Mode Instability in Fiber Amp…
We study the transverse mode instability (TMI) in the limit where a single higher-order mode (HOM) is present. We demonstrate that when the beat length between the fundamental mode and the HOM is small compared to the length scales on which…
High-power fiber laser amplifiers have enabled an increasing range of applications in industry, medicine and defense. The power scaling for narrow-band amplifiers is currently limited by the transverse modal instability. Various techniques…
We experimentally analyze the average-power-scaling capabilities of ultrafast, thulium-doped fiber amplifiers. It has been theoretically predicted that thulium-doped fiber laser systems, with an emission wavelength around 2 um, should be…
We report on detailed in-situ distributed temperature measurements inside a high power fiber amplifier. The deducted thermal load and the TMI-threshold of a commercial LMA fiber with 25 micron core and 400 micron cladding was measured at…
Wavefront shaping has become a powerful tool for manipulating light propagation in various complex media undergoing linear scattering. Controlling nonlinear optical interactions with spatial degrees of freedom is a relatively recent but…
In this paper intermodal modulational instability (IM-MI) is analyzed in a multimode fiber where several spatial and polarization modes propagate. The coupled nonlinear Schr\"{o}dinger equations describing the modal evolution in the fiber…
We report on the influence of core NA on thermal-induced mode instabilities (MI) in high power fiber amplifiers. Influence of core NA and V-parameter on MI has been investigated numerically. It shows that core NA has larger influence on MI…
We show by detailed numerical modeling that stimulated thermal Rayleigh scattering can account for the modal instability observed in high power fiber amplifiers. Our model illustrates how the instability threshold power can be maximized by…
We use a detailed numerical model of stimulated thermal Rayleigh scattering to compute mode instability thresholds in Tm$^{3+}$-doped fiber amplifiers. The fiber amplifies 2040 nm light using a 790 nm pump. The cross-relaxation process is…
We present detailed studies of the effect of polarization on thermal-induced mode instability (MI) in ytterbium-doped fiber amplifiers. Based on a steady-state theoretical model, which takes both electric fields along the two principal axes…
We investigated the effct of pump wavelength on the modal instabilities (MI) in high power linearly-polarized Yb-doped fiber amplifiers. We built a novel semi-analytical model to determine the frequency coupling characteristics and power…
In this letter, the impact of pump configuration on the modal instabilities (MI) threshold of high power fiber amplifiers is investigated. Using a time dependent computer model based on the optical beam propagation method (BPM), the effect…
Dependence of mode instabilities (MI) on ytterbium dopant concentrations in high power fiber amplifiers has been investigated. It is theoretically shown that, by only varying the fiber length to maintain the same total small-signal pump…
Multimode fibers have been proposed for mitigating nonlinear effects in high-power fiber amplifiers, allowing for significant power scaling. Most previous studies on light propagation in continuous-wave fiber amplifiers focus on single mode…
Multimode fibers provide a promising platform for realizing high-power laser amplifiers with suppressed nonlinearities and instabilities. The potential degradation of optical beam quality has been a major concern for highly multimode fiber…
Previous studies of the modulation instability (MI) of continuous waves (CWs) in a two-core fiber (TCF) did not consider effects caused by co-propagation of the two polarized modes in a TCF that possesses birefringence, such as cross-phase…
We develop a high-power narrow-linewidth fiber amplifier based on a tapered Yb-doped fiber. In the experiment, the narrow end of the tapered fiber is used as the input port of both pump source and signal light to form a robust all-fiber…
We numerically model fiber amplifier performance near and slightly above the mode instability threshold. These results are compared with recently published experimental work. Using weakly amplitude modulated pump light we obtain qualitative…
High-power single-frequency fiber amplifiers are increasingly dominant in technologies that require high optical power, stability, and coherence simultaneously. In this chapter, we first provide an overview of their key characteristics,…
Three mode parametric instability has been predicted in Advanced gravitational wave detectors. Here we present the first observation of this phenomenon in a large scale suspended optical cavity designed to be comparable to those of advanced…