相关论文: Training-Free Energy Beamforming Assisted by Wirel…

Wireless power transfer (WPT) using energy beamforming is a promising solution for low power Internet of Things (IoT) devices. In this work, we consider WPT from an energy transmitter (ET) employing retrodirective WPT using a large phased…

Integrating different functionalities, conventionally implemented as dedicated systems, into a single platform allows utilising the available resources more efficiently. We consider an integrated sensing and power transfer (ISAPT) system…

This paper maximizes the achievable throughput of a relay-assisted wirelessly powered communications system, where an energy constrained source, helped by an energy constrained relay and both powered by a dedicated power beacon (PB),…

Wireless energy transfer (WET) is a green enabler of low-power Internet of Things (IoT). Therein, traditional optimization schemes relying on full channel state information (CSI) are often too costly to implement due to excessive energy…

This paper studies an intelligent reflecting surface (IRS)-assisted multiuser multiple-input single-output (MISO) simultaneous wireless information and power transfer (SWIPT) system. In this system, a multi-antenna access point (AP) uses…

This paper studies a cognitive or secondary multi-antenna wireless power transfer (WPT) system over a multi-carrier channel, which shares the same spectrum with a primary wireless information transfer (WIT) system that employs adaptive…

Radio frequency (RF) wireless power transfer (WPT) is a key technology for future low-power wireless systems. However, the inherently low end-to-end power transfer efficiency (PTE) is challenging for practical applications. The main factors…

This paper considers an unmanned aerial vehicle (UAV)-enabled wireless power transfer (WPT) system, in which a UAV equipped with a directional antenna is dispatched to deliver wireless energy to charge two energy receivers (ERs) on the…

Multi-antenna or multiple-input multiple-output (MIMO) technique can significantly improve the efficiency of radio frequency (RF) signal enabled wireless energy transfer (WET). To fully exploit the energy beamforming gain at the energy…

In this letter, we study the robust beamforming problem for the multi-antenna wireless broadcasting system with simultaneous information and power transmission, under the assumption of imperfect channel state information (CSI) at the…

Wirelessly-powered sensor networks (WPSNs) are becoming increasingly important in different monitoring applications. We consider a WPSN where a multiple-antenna base station, which is dedicated for energy transmission, sends pilot signals…

In this paper, we study a multi-sine multiple-input multiple-output (MIMO) wireless power transfer (WPT) system with the objective to increase the output DC power. We jointly optimize the multi-sine waveform and beamforming accounting for…

In the field of WiFi sensing, as an alternative sensing source of the channel state information (CSI) matrix, the use of a beamforming feedback matrix (BFM)that is a right singular matrix of the CSI matrix has attracted significant interest…

Distributed antenna systems (DAS) have been widely implemented in state-of-the-art cellular communication systems to cover dead spots. Recent studies have also indicated that DAS have advantages in wireless energy transfer (WET). In this…

This letter studies a radio-frequency (RF) multi-user wireless power transfer (WPT) system, where an energy transmitter (ET) with a large number of antennas delivers energy wirelessly to multiple distributed energy receivers (ERs). We…

The dual use of radio signals for simultaneous wireless information and power transfer (SWIPT) has recently drawn significant attention. To meet the practical requirement that energy receivers (ERs) operate with much higher received power…

This paper unveils the importance of intelligent reflecting surface (IRS) in a wireless powered sensor network (WPSN). Specifically, a multi-antenna power station (PS) employs energy beamforming to provide wireless charging for multiple…

Distributed beamforming is a key enabler to provide power wirelessly to a massive amount of energy-neutral devices (ENDs). However, without prior information and fully depleted ENDs, initially powering these devices efficiently is an open…

Wireless power transfer (WPT) is an emerging paradigm that will enable using wireless to its full potential in future networks, not only to convey information but also to deliver energy. Such networks will enable trillions of future…

In this paper, we explore cooperative sensing and communication within cell-free integrated sensing and communication (ISAC) systems. Specifically, multiple transmit access points (APs) collaboratively serve multiple communication users…