相关论文: Hierarchical-Absolute Reciprocity Calibration for …

Distributed massive MIMO networks are envisioned to realize cooperative multi-point transmission in next-generation wireless systems. For efficient cooperative hybrid beamforming, the cluster of access points (APs) needs to obtain precise…

One of the biggest challenges in operating massive multiple-input multiple-output systems is the acquisition of accurate channel state information at the transmitter. To take up this challenge, time division duplex is more favorable thanks…

Hybrid beamforming (HBF) includes analog beamforming with phase shifted array in RF domain and digital beamforming in baseband domain. Phase shifted array is usually made up with a large amount of phase shifters. Limited to the…

Hybrid analog-digital (AD) beamforming structure is a very attractive solution to build low cost massive multiple-input multiple-output (MIMO) systems. Typically these systems use a set of fixed beams for transmission and reception to avoid…

The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…

In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…

Full duplex (FD) is an auspicious wireless technology that holds the potential to double data rates through simultaneous transmission and reception. This paper proposes two innovative designs of hybrid beamforming (HYBF) for a multicell…

In millimeter-wave (mmWave) dual-function radar-communication (DFRC) systems, hybrid beamforming (HBF) is recognized as a promising technique utilizing a limited number of radio frequency chains. In this work, in the presence of extended…

Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…

In time-division-duplexing (TDD) massive multiple-input multiple-output (MIMO) systems, channel reciprocity is exploited to overcome the overwhelming pilot training and the feedback overhead. However, in practical scenarios, the…

Millimeter Wave (mmWave) communications with full-duplex (FD) have the potential of increasing the spectral efficiency, relative to those with half-duplex. However, the residual self-interference (SI) from FD and high pathloss inherent to…

Hybrid beamforming (HBF) is an attractive technology for practical massive multiple-input and multiple-output (MIMO) millimeter wave (mmWave) systems. Compared with the fully-connected HBF architecture, the partially-connected one can…

To satisfy the capacity requirements of future mobile systems, under-utilized millimeter wave frequencies can be efficiently exploited by employing massive MIMO technology with highly directive beamforming. Hybrid analog-digital beamforming…

Time-division-duplexing massive multiple-input multiple-output (MIMO) systems estimate the channel state information (CSI) by leveraging the uplink-downlink channel reciprocity, which is no longer valid when the mismatch arises from the…

Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…

Millimeter-wave (mmWave) communications and cell densification are the key techniques for the future evolution of cellular systems beyond 5G. Although the current mmWave radio designs are focused on hybrid digital and analog receiver array…

Full Duplex (FD) radio has emerged as a promising solution to increase the data rates by up to a factor of two via simultaneous transmission and reception in the same frequency band. This paper studies a novel hybrid beamforming (HYBF)…

Hybrid analog and digital BeamForming (HBF) is one of the enabling transceiver technologies for millimeter Wave (mmWave) Multiple Input Multiple Output (MIMO) systems. This technology offers highly directional communication, which is able…

Phase synchronization among distributed transmission reception points (TRPs) is a prerequisite for enabling coherent joint transmission and high-precision sensing in millimeter wave (mmWave) cell-free massive multiple-input and…

Hybrid analog and digital beamforming (HBF) has recently emerged as an attractive technique for millimeter-wave (mmWave) communication systems. It well balances the demand for sufficient beamforming gains to overcome the propagation loss…