相关论文: Multi-User Wireless Communications with Holographi…

Reconfigurable Intelligent Surfaces (RISs) are one of the key emerging 6th Generation (6G) technologies that are expected to improve the link budgets between transmitters and receivers by adding artificial propagation paths. In such…

The recent concept of beamspace multiple input multiple output (MIMO) can significantly reduce the number of required radio-frequency (RF) chains in millimeter-wave (mmWave) massive MIMO systems without obvious performance loss. However,…

Massive multi-input multi-output (MIMO) uses a very large number of low-power transmit antennas to serve much smaller numbers of users. The most widely proposed type of massive MIMO transmit beamforming is zero-forcing, which is based on…

Holographic metasurface transceivers (HMT) is an emerging technology for enhancing the coverage and rate of wireless communication systems. However, acquiring accurate channel state information in HMT-assisted wireless communication systems…

Holographic multiple-input multiple-output (HMIMO) is a potential technique for improving spectral efficiency (SE) while maintaining low hardware cost and power consumption. Although conventional alternating optimization (AO) methods are…

Massive multi-user multiple-input multiple-output (MU-MIMO) systems enable high spatial resolution, high spectral efficiency, and improved link reliability compared to traditional MIMO systems due to the large number of antenna elements…

Cell-free (CF) massive multiple-input-multiple-output (mMIMO) deployments are usually investigated with half-duplex nodes and high-capacity fronthaul links. To leverage the possible gains in throughput and energy efficiency (EE) of…

Sixth-generation (6G) networks are expected to provide ubiquitous connectivity across terrestrial and non-terrestrial domains. This will be possible by integrating non-terrestrial networks (NTNs) to extend coverage to underserved areas.…

To improve the cellular energy efficiency, without sacrificing quality-of-service (QoS) at the users, the network topology must be densified to enable higher spatial reuse. We analyze a combination of two densification approaches, namely…

In order to ensure the fastest wireless energy transfer from a source to the user one needs to maximize the channel capacity for power transport. In communications technologies, the concept of MIMO (multiple input, multiple output) exploits…

Accurate multiple-input multiple-output (MIMO) channel estimation is critical for next-generation wireless systems, enabling enhanced communication and sensing performance. Traditional model-based channel estimation methods suffer, however,…

Many emerging technologies, such as ultra-massive multiple-input multiple-output (UM-MIMO), terahertz (THz) communications are under active discussion as promising technologies to support the extremely high access rate and superior network…

The capacity of commercial massive multiple-input multiple-output (mMIMO) systems is constrained by the limited array aperture at the base station, and cannot meet the ever-increasing traffic demands of wireless networks. Given the array…

Cell-free massive multiple-input multiple-output (CF mMIMO) systems serve the user equipments (UEs) by geographically distributed access points (APs) by means of joint transmission and reception. To limit the power consumption due to…

A practical and scalable multicast beamformer design in multi-input multi-output~(MIMO) coded caching~(CC) systems is introduced in this paper. The proposed approach allows multicast transmission to multiple groups with partially…

Cell-free (CF) massive multiple-input multiple-output (MIMO) systems, which exploit many geographically distributed access points to coherently serve user equipments via spatial multiplexing on the same time-frequency resource, has become a…

To support the high data rates for latency-critical applications, future wireless systems will employ fully digital beamforming multiple-input multiple-output (MIMO) architectures at millimeter wave (mmWave) frequencies. Moreover, mmWave…

This paper investigates the user grouping problem of downlink wireless local area networks (WLANs) with multi-user MIMO (MU-MIMO). Particularly, we focus on the problem of whether single user transmit beamforming (SU-TxBF) or MU-MIMO should…

With the versatile manipulation capability, programmable metasurfaces are rapidly advancing in their intelligence, integration, and commercialization levels. However, as the programmable metasurfaces scale up, their control configuration…

This work investigates a multi-user, multi-antenna uplink wireless system, in which multiple users transmit signals to a base station. Prior research has explored the potential for linear growth in spectral efficiency by employing multiple…