相关论文: Over-the-Air Computation with Imperfect Channel St…

Modern IEEE 802.11 (Wi-Fi) networks extensively rely on multiple-input multiple-output (MIMO) to significantly improve throughput. To correctly beamform MIMO transmissions, the access point needs to frequently acquire a beamforming matrix…

Intelligent Reflecting Surface (IRS) utilizes low-cost, passive reflecting elements to enhance the passive beam gain, improve Wireless Energy Transfer (WET) efficiency, and enable its deployment for numerous Internet of Things (IoT)…

Most works in IRS-assisted systems have ignored the impact of the inevitable residual hardware impairments (HWIs) at both the transceiver hardware and the IRS while any relevant works have addressed only simple scenarios, e.g., with…

One basic operation of Internet-of-Things (IoT) networks is aggregating distributed sensing-data over wireless-channels for function-computation, called wireless-data-aggregation (WDA). Targeting dense sensors, a recently developed…

Cell-free (CF) massive multiple-input multiple-output (MIMO) systems are expected to implement advanced cooperative communication techniques to let geographically distributed access points jointly serve user equipments. Building on the…

Over-the-air computation (OAC) is a promising wireless communication method for aggregating data from many devices in dense wireless networks. The fundamental idea of OAC is to exploit signal superposition to compute functions of multiple…

The point-to-point multiple-antenna channel is investigated in uncorrelated block fading environment with Rayleigh distribution. The maximum throughput and maximum expected-rate of this channel are derived under the assumption that the…

We consider a multiuser (MU) multiple-input multiple-output (MIMO) time-division duplexing (TDD) system in which the base station (BS) is equipped with a large number of antennas for communicating with single-antenna mobile users. In such a…

This paper studies a memoryless state-dependent multiple access channel (MAC) where two transmitters wish to convey a message to a receiver under the assumption of causal and imperfect channel state information at transmitters (CSIT) and…

Beamforming is a widely used method of provisioning high quality wireless channels that leads to high data rates and simple decoding structures. It requires feedback of Channel State Information (CSI) from receiver to transmitter, and the…

In this paper, we investigate the design of robust and secure transmission in intelligent reflecting surface (IRS) aided wireless communication systems. In particular, a multi-antenna access point (AP) communicates with a single-antenna…

This paper considers the joint transceiver design for downlink multiuser multiple-input single-output (MISO) systems with coordinated base stations (BSs) where imperfect channel state information (CSI) is available at the BSs and mobile…

Accurate channel impulse response (CIR) is required for coherent detection and it can also help improve communication quality of service in next-generation wireless communication systems. One of the advanced systems is multi-input…

Cognitive radios have been proposed as agile technologies to boost the spectrum utilization. This paper tackles the problem of channel estimation and its impact on downlink transmissions in an underlay cognitive radio scenario. We consider…

Intelligent reflecting surfaces (IRSs) have received considerable attention from the wireless communications research community recently. In particular, as low-cost passive devices, IRSs enable the control of the wireless propagation…

This paper presents an end-to-end deep learning framework in a movable antenna (MA)-enabled multiuser communication system. In contrast to the conventional works assuming perfect channel state information (CSI), we address the practical CSI…

This paper studies receiver design in single-input multiple-output (SIMO) slow fading channels with imperfect channel state information (CSI) at the receiver only. Using generalized mutual information (GMI) as achievable rate, we study the…

Channel estimation and precoding in hybrid analog-digital millimeter-wave (mmWave) MIMO systems is a fundamental problem that has yet to be addressed, before any of the promised gains can be harnessed. For that matter, we propose a method…

The recent combination of the rising architectures, known as stacked intelligent metasurface (SIM) and holographic multiple-input multiple-output (HMIMO), drives toward breakthroughs for next-generation wireless communication systems. Given…

Reconfigurable intelligent surfaces (RIS) is a promising solution to build a programmable wireless environment via steering the incident signal in fully customizable ways with reconfigurable passive elements. In this paper, we consider a…